1:43 Full Proportion Four-Wheel Drive Drift Model High-Speed Car

Instruction Manual

Product configuration:

Need to buy:

Battery precautions:

  1. It is recommended to use 1.5V AAA alkaline battery in the remote control.
  2. Do not mix alkaline batteries or rechargeable batteries.
  3. Ensure that the battery is inserted with the correct polarity.
  4. Do not short circuit the power terminal.
  5. Battery replacement can only be done by adults.
  6. *After the remote control is successfully connected to the vehicle, the remote control indicator light blinks slowly during the control process, indicating that the remote control battery is insufficient and needs to be replaced.

Care and maintenance:

  1. Avoid long-term exposure or heat in the sun.
  2. Check whether all screws are loose.
  3. When not in use for a long time, please take out the battery in the remote control and place it separately.

Remote control battery assembly:

1. Loosen the fixing screws.

2. Open the battery compartment and install four 1.5V AAA batteries with the correct polarity (+/-).

3. Close the battery cover and tighten the screws.

Diagram shows three steps: Step 1: Loosen fixing screws. Step 2: Insert four 1.5V AAA batteries with correct polarity. Step 3: Close and tighten the battery cover.

Remote control car function and remote control button description:

  1. The switch position of the vehicle and remote control is toggle to the ON position, and the frequency is automatically adjusted. When preparing to open the switch frequency of the remote control, ensure that the throttle trigger and steering handwheel are not involved in the middle position.
  2. The vehicle speed has 3 gears, adjust the gear through the remote control button, the remote control indicator is red for high-speed gear 100%, yellow for medium speed gear 50%, green for low speed gear 20%, adjust the speed according to different tracks.
  3. If the vehicle is not running in a straight line, you can fine-tune the left and right through the TRIM button on the side of the remote control.
  4. The [light switch] button on the remote control panel can achieve the control effect of the lamp switch, and the [double flash] button can control the remote control car to open or close the double flashing light mode. (The double flash function must be switched when the lights are on)
  5. Remote control car tires have two configurations: racing tires and drifting tires. (Model 4303 has a small front wheel and a large rear wheel, please pay attention to the distinction)
Diagram of the remote control: 1. Switch (dual-blinking mode indicator), 2. Speed gear plus, 3. Speed gear reduction, 4. Power switch, 5. TRIM Left-trim, 6. Speed indicator, 7. Light switch, 8. TRIM Right-trim, 9. Direction wheel, 10. Throttle. Car diagram labels: 'Type-C port', 'Front wheel', 'Rear-wheel', 'Base chassis', 'Power switch'.

How to drive a remote control car:

  1. Pull the throttle trigger back, the remote control car moves forward. The throttle trigger angle controls the speed of the remote control car forward, achieving full ratio control.
  2. Push the throttle trigger forward for the first time to activate the brake function. Then, push forward again after returning to the center to make the remote control car reverse. The angle of the throttle trigger controls the reverse speed.
  3. The steering wheel controls the steering of the remote control car by turning left and right. The steering wheel angle controls the steering angle to achieve full ratio control.
Diagrams illustrate car movement: Throttle trigger controls forward speed and reverse. Steering wheel controls direction.

Vehicle charging precautions:

Use the conventional mobile phone charging adapter to charge the vehicle through the matching Type-C charging cable. The charging time is about 30 minutes. When the vehicle charging indicator is off, it indicates that the vehicle battery is charged. Please remove the charging cable in time and do not connect the charger for a long time. Before charging, ensure that the vehicle power switch is in the OFF state.

*During the use of the vehicle, if the steering gear is slow, no response, or the vehicle operation is unresponsive, and the lights continue to flash short, it means that the remote control car battery is insufficient, and the vehicle power supply needs to be turned off for charging operation.

Diagram shows the vehicle's 'Type-C port' and a 'Li-ion' battery symbol, with 'MADE IN CHINA' and 'CE' markings.

Attention:

Mobile phone charging head power can not be greater than 25 watts. Such as using a high-power mobile phone charging head to charge the vehicle, it is very likely to damage the vehicle circuit board and battery.

  1. Charging must be operated by adults; do not let children charge themselves.
  2. This product is only suitable for use by players over 14 years old. Use under 14 years old may cause security risks or abnormal damage to the product.
  3. The product has no waterproof function, and the parts should be kept dry.
  4. Keep all chemicals, small parts, and other electronic accessories out of reach of children.
  5. The battery in the car is a 3.7V lithium battery; please do not puncture the battery and remove it violently to avoid the risk of fire.
  6. Do not use high-power mobile phone chargers to charge the vehicle, otherwise there will be fire and other safety hazards.
  7. Check whether the wires, plugs, shells, and other parts are damaged before charging, and stop using them until they are repaired.
  8. Pay attention to the polarity of the battery when installing the remote control.
  9. The remote control car battery is 200mAh 3.7V high-performance lithium battery, and the remote control uses four 1.5V AAA batteries.

Driving skills:

  1. Piles can be arranged indoors for fixed-point drift practice or 8-figure cyclic drift practice.
  2. The racing track can be arranged to realize the racing competition.

Common problems and failures

Common problems and failuresFault cause and troubleshooting method
After the battery power indicator on the remote control is off or the frequency is successfully set, the indicator blinks slowly
  1. Take out battery No. 7 and check whether the positive and negative terminals are correctly connected.
  2. Check whether the battery is powered on. If the indicator blinks slowly, the battery is low.
  3. If the battery cover is not properly installed, check whether the battery cover is properly installed and tighten the screws on the battery cover.
The vehicle cannot drive in a straight line
  1. Use the remote control to turn the fine-tuning button to fine-tune until the vehicle can normally go straight.
  2. Check whether the four wheels are stuck and clean up the foreign bodies in time.
After the vehicle is connected to the remote control, the remote control does not operate, and the wheels are still runningTurn off the remote control and make sure the throttle trigger and steering wheel turn on the remote control in the middle position.
Vehicle steering failure or vehicle power failure, lights flashThe vehicle is out of power; charge the vehicle in time.
The vehicle has no reverse function
  1. Turn off the remote control and reset the frequency.
  2. The first forward push of the throttle trigger is the brake function, and the second forward push of the throttle trigger after the throttle returns to the middle position is the reverse function.
When the vehicle is driving, the resistance is very strong or it cannot drive at all
  1. Check whether the four outer tires are displaced and stuck under the car.
  2. Check whether the four wheels are stuck and clean up the foreign bodies in time.
There is no response to the vehicle remote control or there is a delay in steering the throttle
  1. The remote control battery is out of power; replace the remote control battery in time.
  2. The vehicle is beyond the remote control range; ensure that the vehicle is controlled within 20 meters.
  3. There may be strong signal interference sources nearby; it is recommended to change the location to control the remote control car.

FCC Compliance Statements

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

PDF preview unavailable. Download the PDF instead.

Sa996c3e983e740639e85c2f0e44b5b98I Adobe Photoshop for Windows -- Image Conversion Plug-in

Related Documents

Preview 1:24 High Speed Drift Remote Control Car Instruction Manual
Instruction manual for the 1:24 High Speed Drift Remote Control Car, covering setup, operation, maintenance, and troubleshooting. Includes battery requirements, driving tips, and safety warnings.
Preview WLtoys 104001 RC Car Driving Techniques and Guide
Learn essential driving techniques for the WLtoys 104001 RC car, covering speed control, obstacle navigation, and track driving for enhanced performance and enjoyment.
Preview WLtoys 1/16 RC Car Transmitter Functions and Operation Guide
A comprehensive guide detailing the functions and operation of the WLtoys 1/16 scale RC car transmitter, covering controls, indicators, and modes for optimal performance.
Preview WLtoys 284161 1:28 Electric 4WD Short Truck User Manual
Comprehensive user manual for the WLtoys 284161 1:28 scale electric 4WD short course RC truck, detailing assembly, parts, and operation. Includes safety guidelines and parts list.
Preview Instruction Manual - WLtoys 6401 RC Car
Detailed instruction manual for the WLtoys 6401 1/64 FPV Mini RC Car, covering function descriptions, parameters, charging instructions, and WiFi connection precautions.
Preview WLtoys 144010 V8 RC Car User Manual and Assembly Guide
This user manual provides essential safety information, technical specifications, and detailed assembly instructions for the WLtoys 144010 V8 1:14 scale high-speed RC car. It also includes a comprehensive parts list for easy identification.
Preview WLtoys 6401 RC Car Instruction Manual
Comprehensive instruction manual for the WLtoys 6401 Mini RC Car, detailing function key descriptions, basic car functions, WiFi module parameters, charging instructions, and usage precautions.
Preview WLtoys L959 1:12 2WD Off-road Buggy RC Car Instruction Manual
Comprehensive instruction manual for the WLtoys L959 1:12 2WD Off-road buggy RC car. Covers contents, specifications, safety precautions, battery charging, how to drive, troubleshooting, and warranty information.