Instruction Manual

Overview

This section provides a visual overview of the Flush Mount Lighting fixture and its components.

The fixture is a decorative Flush Mount Lighting unit. The overview diagram illustrates the assembly and wiring connections:

• Outlet box: The electrical box in the ceiling.
• Wires from Outlet Box: Black (smooth), White (ribbed), and Green (Ground, bare copper wire).
• Fixture Components:
  • A. Fixture body: The main decorative part of the light.
  • B. Shade: The decorative cover, often made of glass or fabric.
  • C. Socket ring: Secures the shade to the socket.
  • E. Canopy: The decorative plate that covers the electrical box.
  • D. Finial: A decorative knob or cap that secures the canopy.
  • F. Mounting strap: A metal bracket that attaches to the outlet box to support the fixture.
  • G. Screw: Used to attach the mounting strap to the outlet box.

The diagram shows how the fixture's wires connect to the house wires and how the mounting strap and canopy are installed.

Assembly Instruction

1. Attach Shade (B) onto the socket, then tighten with Socket ring (C).
2. Fix Mounting strap (F) to the outlet box with Screw (G).
3. Connect the wires according to the wiring instructions provided in the next section.
4. Pass Canopy (E) through the screw and fix it with Finial (D).

Wiring Instruction

1. Insert the green grounding screw into the hole with two raised dimples on the mounting bar. Wrap the ground wire from the fixture (if supplied) around the green grounding screw, then connect it to the ground wire from the outlet box (if not fixed on the outlet box) using a wire connector (not supplied). If the ground wire from the fixture is not supplied, wrap the ground wire (if not fixed on the outlet box) from the outlet box around the green grounding screw and tighten it.
2. NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES.
3. Take note of the color of the wire(s) on your fixture. Identify which group your fixture wire(s) falls into and connect the wires according to the directions below:

3. Take your fixture wire(s) from [Group A] and place evenly against the black wire from the outlet box. Do NOT twist wires together before using wire connectors.
4. Fit a wire connector over the wires and screw the connector clockwise until you feel firmness.
5. Try gently to pull the connector off the wires. If you can pull the connector off, carefully re-do steps 3 and 4 as above, and check again for a firm connection.
6. Connect the fixture wire from [Group B] to the white wire from the outlet box in the same manner. Make sure no bare wires can be seen outside wire connectors.

Product Specifications

Input voltage: 120V

Rated power: 40W MAX

Lamp socket: E26

Product Packaging

• Fixture body x 1
• Mounting strap x 1
• Screw x 2 & Wire nut x 3
• Shade x 1
• Lamp instruction x 1

Cleaning

To clean, wipe the fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as scouring pads or powders, steel wool, or abrasive paper.

Safety Information

Always switch off the electricity supply and allow the fixture to cool for 10 minutes before changing the light bulbs.

Contact Us

E-mail: service@24h-reply.com

Print in China