Introduction
This guide provides detailed instructions for the installation and setup of the Lutron Emergency Lighting Interface (LUT-ELI-3PH). This interface is designed to seamlessly integrate with various Lutron lighting control systems, ensuring emergency lighting functionality during power outages.
It covers essential information including system overview, mounting procedures, wiring diagrams for different Lutron systems such as GRAFIK Eye QS, EcoSystem, Quantum, and panel-based systems with circuit selectors or legacy panel interfaces. The document also includes important safeguards and troubleshooting tips to ensure proper and safe installation.
Key Features and Compatibility
The Emergency Lighting Interface detects loss of normal power and signals compatible Lutron products to activate emergency lighting modes. It supports a wide range of Lutron systems, including:
- GRAFIK Eye QS units
- Energi Savr Node units
- EcoSystem bus supply
- Quantum bus supply
- LCP/XPS controllers
- Vive systems
- Legacy panel interfaces
For detailed wiring and system compatibility, refer to the specific sections within this guide.
Important Safeguards
Always adhere to national and local electrical codes and safety standards. Ensure power is switched off before commencing any installation or wiring. The interface is intended for indoor use only and should be installed in locations protected from tampering.
Further Information
For the most up-to-date information, including installation, operation, and maintenance instructions, please visit the official Lutron website at www.lutron.com.
Lutron | Intelligent light. Automated Shades. Powerful Controls
