Beldray TURBOBOOST Cordless Instruction Manual

Product Overview

A sleek, modern cordless stick vacuum cleaner is depicted, featuring a silver extension tube and black main unit and floor head. The Beldray logo, with "est 1872" above it, is prominently displayed. The text "Our versatile, ultra-light & cordless vacuum cleaner" and "TURBOBOOST CORDLESS INSTRUCTION MANUAL" are also visible. A website address "www.beldray.com" is shown at the bottom right.

Safety Instructions

Please retain these instructions for future reference.

When using electrical appliances, basic safety precautions should always be followed. Check that the voltage indicated on the rating plate corresponds with that of the local network before connecting the appliance to the mains power supply.

Children aged from 8 years and people with reduced physical, sensory or mental capabilities or lack of experience and knowledge can use this appliance, only if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children should be supervised to ensure that they do not play with the appliance. Unless they are older than 8 and supervised, children should not perform cleaning or user maintenance.

If the power supply cord, plug or any part of the appliance is malfunctioning or if it has been dropped or damaged, cease using the product immediately to avoid potential injury.

This appliance contains no user serviceable parts; only a qualified electrician should carry out repairs. Improper repairs may place the user at risk of harm.

Do not remove the adaptor from the mains power supply by pulling the cord; switch off and remove the plug by hand. Do not use the adaptor to recharge non-rechargeable batteries. Do not use the appliance for anything other than its intended use. Take care when equipping accessories with rotating parts as this could cause entrapment.

Switch off the appliance, disconnect it from the mains power supply and allow to cool fully before changing or fitting accessories and before cleaning or user maintenance. Use of an extension cord with the appliance is not recommended.

This appliance should not be operated by means of an external timer or separate remote control system. This appliance is intended for domestic use only. It should not be used for commercial purposes.

Battery Safety

The supply terminals are not to be short-circuited. In the event of a battery pack leaking, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected area with copious amounts of water and seek medical advice.

Secondary cells and batteries need to be charged before use. After extended periods of storage, it may be necessary to charge and discharge the battery pack several times to obtain maximum performance.

Do not leave a battery pack on prolonged charge when not in use. Do not use any charger other than that specifically provided for use with the appliance. Do not use any cell or battery which is not designed for use with the appliance.

Keep batteries out of the reach of children. Do not crush, puncture, dismantle or otherwise damage the battery pack. Do not store above 60 °C. Avoid storage in direct sunlight. Do not expose the battery pack to heat or fire as it may explode. Do not subject the battery pack to mechanical shock.

To dispose of the exhausted battery pack, take it to a local recycling station. Contact the local government offices for further details. This appliance is fitted with a 22.2 V 2200 mAh Li-ion rechargeable battery.

Dos and Don'ts

Do:

• Charge the vacuum cleaner fully before first use.
• Check that the HEPA filter is kept clear of obstruction.
• Make sure that the dust container and HEPA filter are cleaned regularly to preserve suction and prolong the life of the vacuum cleaner.
• Clean the dust container and HEPA filter at least every three weeks with clean water to keep the vacuum cleaner working efficiently.

Don't:

• Use the vacuum cleaner without the HEPA filter or dust container in position.
• Use the vacuum cleaner to pick up flammable liquid, matches, cigarette ends, hot ashes or any hot, burning or smoking objects.
• Use the vacuum cleaner to pick up water or any other liquid, as this poses risk of an electric shock.

Care and Maintenance

Wipe the external surface of the vacuum cleaner with a soft, damp cloth and allow to dry thoroughly. Do not use any harsh or abrasive detergents or cleaning agents to clean any part of the vacuum cleaner. Keep the HEPA filter clean and replace when it becomes worn.

Description of Parts

The vacuum cleaner and its accessories are comprised of the following parts:

Instructions for Use

Before First Use

Before using the vacuum cleaner for the first time, clean the exterior surface with a soft, damp cloth and dry thoroughly. Do not immerse the vacuum cleaner in water or any other liquid.

Charging the 22.2 V Turbo Boost

Before first use, the vacuum cleaner must be charged for approx. 4-5 hours. Subsequent charging times will vary dependent on use. If the vacuum cleaner battery becomes drained completely during use, it may take up to 4-5 hours to fully recharge.

1. Check that the vacuum cleaner is switched off.
2. Connect the mains power adaptor to the charging port on the handheld unit.
3. Plug the mains power adaptor into the mains power supply; the LED indicator lights will flash during charging and remain illuminated once the battery is fully charged.

WARNING: Do not use any mains power adaptor other than that supplied. Using an alternative will increase the risk of damage to the vacuum cleaner or injury to the user.

If the LED lights do not illuminate when the charger is first plugged in:

1. Unplug the charger from the vacuum cleaner.
2. Turn on the vacuum cleaner for approx. 5 seconds.
3. Turn off the vacuum cleaner.
4. Reattach the charger to the vacuum cleaner; make sure it is fully inserted into the charging port. The LED lights should now illuminate to indicate that the vacuum cleaner is charging.

Using the 22.2 V Turbo Boost

1. Check that the vacuum cleaner is disconnected from the mains power adaptor after unplugging it from the mains power supply.
2. Turn on the vacuum cleaner by pressing the power trigger; press the speed control button for the maximum power setting, press again to use the minimum power setting.
3. To turn off the vacuum cleaner, press the power trigger.

WARNING: Do not use the vacuum cleaner without the HEPA filter and filter cone in position. Clean the HEPA filter every 2 weeks to preserve the suction of the vacuum cleaner.

Using the Extension Tube and Floor Brush

The extension tube can be fitted onto the air inlet to extend reach, ideal for floor-to-ceiling cleaning.

1. Fit the extension tube onto the air inlet by aligning the pins and carefully pushing the extension tube towards the vacuum cleaner main unit until it clicks into position. To release the extension tube, press the extension tube release button and pull it away from the vacuum cleaner main unit.
2. Attach the floor brush by aligning the pins on the floor brush with the bottom of the extension tube. Carefully push together to secure into place. To release the floor brush, press the floor brush release button and pull it away from the extension tube.
3. Turn on the vacuum cleaner by pressing the power button.

NOTE: The floor brush can also be attached directly onto the handheld unit by aligning the pins on the floor brush with the air inlet on the handheld unit. Carefully push together to secure the floor brush in place.

Using the 22.2 V Turbo Boost Crevice and Brush Tool

1. If required, fit the extension tube onto the air inlet following the instructions in the section entitled 'Using the Extension Tube and Floor Brush'.
2. Push the 2 in 1 crevice and brush tool onto the end of the extension tube until it clicks into place. If no extension is required, push the 2 in 1 crevice and brush tool directly onto the air inlet until it clicks into place.
3. Press the button on the accessory and slide the brush bar back to use as a crevice tool, ideal for removing dust and dirt from corners and recesses. Press the button on the accessory and slide the brush bar forward to use as a brush tool, perfect for cleaning upholstery and fabrics.
4. To remove the 2 in 1 crevice and brush tool, press the release button on the vacuum cleaner main unit or extension tube and pull away.

CAUTION: The extension tube contains electrical connections. Do not use to suck up water. Do not immerse in water for cleaning. The extension tube should be checked regularly and must not be used if damaged.

Emptying the Dust Container

Before emptying the dust container, check that the vacuum cleaner is switched off and any attachments have been removed from the air inlet. It is recommended to empty the dust container outdoors.

1. Whilst securely holding the vacuum cleaner main unit, press the dust container base release latch. Empty the dust container slowly and carefully to reduce the amount of dust released back into the atmosphere.
2. Close the dust container by pushing the base closed until the dust container base release latch locks back into position.

NOTE: Always close the dust container base before using the vacuum cleaner.

Cleaning the HEPA Filter

The washable filter can only be accessed when the dust container is open.

1. Open and empty the dust container following the instructions in the section entitled 'Emptying the Dust Container'.
2. Once the dust container is empty, remove the filter cone by rotating it in an anticlockwise direction and lifting it out of the vacuum cleaner main unit.
3. Rotate the HEPA filter in an anticlockwise direction and lift out of the vacuum cleaner main unit. Shake the HEPA filter and filter cone until the majority of the dust has been removed, then rinse under clean, warm water and allow to dry naturally.
4. Once the HEPA filter is fully dry, place it back into the vacuum cleaner main unit and twist in a clockwise direction to lock into position. Replace the filter cone over the filter in the vacuum cleaner main unit and secure into place by rotating the filter cone in a clockwise direction.
5. Close the dust container by pushing it firmly shut until it clicks into position.

Cleaning the Floor Brush

The floor brush has a removable brush bar for easy cleaning.

1. Switch off the vacuum cleaner and remove the floor brush by pressing the floor brush release button and pulling it away from the extension tube.
2. Twist the brush bar release tab lock to the unlocked position and lift up the brush bar release tab.
3. Remove the brush bar by pulling it away from the floor brush.
4. Clean any built-up dust, debris and hair from the brush bar and floor brush.
5. Replace the brush bar into the floor brush by aligning it on both sides. Then push down the brush bar release tab and twist the brush bar release lock to the locked position.

Installing the Wall Mount Storage Base

The wall mount storage base can be fixed to a wall for convenient storage. If you wish to store the vacuum cleaner whilst it is charging, check that the wall mount storage base is close enough to the mains power supply to avoid overstretching the charging wire.

1. Using a pencil, mark the positions of 2 screw holes on the desired surface. The gap between the markings should form a straight line.
2. Using a suitable drill bit, drill pilot holes into the markings. Consult a qualified professional if required.
3. Firmly place the wall plugs into the pilot holes so that they sit flush with the surface of the wall.
4. Position the wall mount storage base onto the surface, aligning the holes on the surface with those on the wall mount storage base.
5. Insert the screws provided through the wall mount storage base and into the wall and tighten so that the wall mount storage base sits flush with the surface. Check that the flat edge of the wall mount storage base is facing upwards.
6. Slide the vacuum cleaner into position on the wall mount storage base, making sure that it engages with the hook.

CAUTION: Check that there are no electrical, plumbing or gas supplies situated beneath the surface of the wall. These services normally run vertically or horizontally behind the wall, and the electrical wiring will radiate from the socket, possibly in more than one direction. Testers are available from good DIY stores. Consult a qualified professional if required.

NOTE: Check that the chosen surface is strong enough to support the wall mount storage base and vacuum cleaner. Make sure that the wall mount is secured at an adequate height to store the fully assembled vacuum cleaner.

Visual Description (Page 9): Diagrams show the components for the wall mount storage base, including brackets, screws, and wall plugs, along with the main unit and extension tube being attached to the mount.

Storage

Check that the vacuum cleaner is cool, clean and dry before storing in a cool, dry place. Store the mains power adaptor separately, checking that it is not bent at the connections, as this could cause damage to the wires.

Troubleshooting

Specifications

• Product code: BEL01644
• Battery: 22.2 V 2200 mAh Li-ion
• Adaptor input: 100-240 V~, 50/60 Hz, 0.5 A
• Adaptor output: 27 V = 0.5 A, 13.5 W
• Average active efficiency: 86.43%
• Efficiency at low load (10%): 74.72 %
• No load power consumption: 0.058 W
• Dust tank capacity: 0.5 L

Guarantee and Disposal

Contact Information:

UP Global Sourcing UK Ltd., Victoria Street, Manchester OL9 0DD. UK. Edmund-Rumpler Straße 5, 51149 Köln. Germany.

If this product does not reach you in an acceptable condition please contact our Customer Services Department at www.beldray.com. Please have your delivery note to hand as details from it will be required. If you wish to return this product please return it to the retailer from where it was purchased with your receipt (subject to their terms and conditions).

Guarantee

All products purchased as new carry a manufacturer's guarantee; the time period of the guarantee will vary dependent upon the product. Where reasonable proof of purchase can be provided, Beldray will provide a standard 12 month guarantee with the retailer from the date of purchase. This is only applicable when products have been used as instructed for their intended, domestic use. Any misuse or dismantling of products will invalidate any guarantee.

Under the guarantee, Beldray undertakes to repair or replace free of any charge any parts found to be defective. In the event that Beldray cannot provide an exact replacement, a similar product will be offered or the cost refunded. Any damages from daily wear and tear are not covered by this guarantee, nor are consumables such as plugs, fuses etc.

Please note that the above terms and conditions may be updated from time to time and it is recommended to check these each time you revisit the website. Nothing in this guarantee or in the instructions relating to this product excludes, restricts or otherwise affects your statutory rights.

Disposal of Waste Batteries and Electrical and Electronic Equipment

The symbol ♻️ on the product, its batteries or its packaging means that this product and any batteries it contains must not be disposed of with household waste. Instead, it is the user's responsibility to hand this over to an applicable collection point for the recycling of batteries and electrical and electronic equipment. This separate collection and recycling will help to conserve natural resources and prevent potential negative consequences for human health and the environment due to the possible presence of hazardous substances in batteries and electrical and electronic equipment, which could be caused by inappropriate disposal.

Some retailers provide take-back services which allow the user to return exhausted equipment for appropriate disposal. It is the user's responsibility to delete any data on electrical and electronic equipment prior to disposal. For more information about where to drop batteries, electrical and electronic waste off, please contact the local city/municipality office, household waste disposal service, or the retailer.

Extended Guarantee: To be eligible for the extended guarantee, go to guarantee.upgs.com/beldray and register your product within 30 days of purchase.

Find us on: facebook.com/Beldray

Manufacturer: UP Global Sourcing UK Ltd., Victoria Street, Manchester OL9 0DD. UK. Edmund-Rumpler Straße 5, 51149 Köln. Germany.

Website: www.beldray.com

Beldray Trademark. All rights reserved. CD141122/MD000000/V1