Beldray Airgility Max Cordless Vacuum Cleaner

Our cordless, powerful & versatile vacuum cleaner

AIRGILITY MAX CORDLESS INSTRUCTION MANUAL

Visit: www.beldray.com

Safety Instructions

Please read all of the instructions carefully and retain for future reference.

When using electrical appliances, basic safety precautions should always be followed.

Check that the voltage indicated on the rating plate corresponds with that of the local network before connecting the appliance to the mains power supply.

Children aged from 8 years and people with reduced physical, sensory or mental capabilities or lack of experience and knowledge can use this appliance, only if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.

Children should be supervised to ensure that they do not play with the appliance.

Unless they are older than 8 and supervised, children should not perform cleaning or user maintenance.

This appliance contains no user serviceable parts. If the power supply cord, plug or any part of the appliance is malfunctioning or if it has been dropped or damaged, do not use. Only a qualified electrician should carry out repairs. Improper repairs may place the user at risk of harm.

Do not remove the adaptor from the mains power supply by pulling the cord; switch off and remove the plug by hand.

Do not use the adaptor to recharge non-rechargeable batteries or any other appliance.

Do not use the appliance for anything other than its intended use.

Take care when equipping accessories with rotating parts as this could cause entrapment.

Switch off the appliance, disconnect it from the mains power supply and allow to cool fully before changing or fitting accessories and before cleaning or user maintenance.

Use of an extension cord with the appliance is not recommended.

Only use the appliance with the power supply unit provided.

This appliance should not be operated by means of an external timer or separate remote control system.

This appliance is intended for domestic use only. It should not be used for commercial purposes.

Caution: The extension tube contains electrical connections.

Do not use to suck up water. Do not immerse in water for cleaning. The extension tube should be checked regularly and must not be used if damaged.

Battery Safety

The supply terminals are not to be short-circuited.

In the event of a battery pack leaking, do not allow the liquid to come in contact with the skin or eyes. If contact has been made, wash the affected area with copious amounts of water and seek medical advice.

Secondary cells and batteries need to be charged before use. After extended periods of storage, it may be necessary to charge and discharge the battery pack several times to obtain maximum performance.

Do not leave a battery pack on prolonged charge when not in use.

Do not use any charger other than that specifically provided for use with the product.

Do not use any cell or battery which is not designed for use with the product.

Keep batteries out of the reach of children.

Do not crush, puncture, dismantle or otherwise damage the battery pack.

Do not store above 60 °C.

Avoid storage in direct sunlight.

Do not expose the battery pack to heat or fire as it may explode.

Do not subject the battery pack to mechanical shock.

Disposal of Battery

To dispose of the exhausted battery pack, take it to a local recycling station. Contact the local government offices for further details.

This appliance is fitted with a 29.6 V 2200 mAh Li-ion rechargeable battery (removable).

Dos and Don'ts

Do:

Don't:

Care and Maintenance

Wipe the external surface of the vacuum cleaner with a soft, damp cloth and allow to dry thoroughly.

Do not use any harsh or abrasive detergents or cleaning agents to clean any part of the vacuum cleaner.

Keep the HEPA filter clean and replace when it becomes worn.

Description of Parts

Diagram showing the main unit, extension tube, floor brush, dust container, and accessories with numbered callouts.

Instructions for Use

Before First Use

Before using the vacuum cleaner for the first time, clean the exterior surface with a soft, damp cloth and dry thoroughly.

Do not immerse the vacuum cleaner in water or any other liquid.

Charging the Airgility Max Cordless

Before first use, the vacuum cleaner must be charged for approx. 5.5 hours. Subsequent charging times will vary dependent upon use. If the vacuum cleaner battery becomes drained completely during use, it may take up to 5.5 hours to fully recharge.

The battery pack must be fitted onto the vacuum cleaner main unit during charging; do not charge the battery pack separately.

  1. Before connecting to the mains power supply, attach the battery pack by aligning it with the main unit and sliding into place until it clicks.
  2. Connect the mains power adaptor to the charging port on the battery pack.
  3. Plug the mains power adaptor into the mains power supply; the LED indicator light will flash during charging and then remain illuminated once the battery is fully charged.
  4. Unplug the mains power adaptor from the mains power supply once the battery is fully charged. Disconnect the mains power adaptor from the charging port on the battery pack.

Note: Whilst charging, the battery pack may become warm.

Warning: Do not use any mains power adaptor other than that supplied. Using an alternative will increase the risk of damage.

Using the Airgility Max Cordless

  1. Check that the vacuum cleaner is disconnected from the mains power adaptor after unplugging it from the mains power supply. Make sure that the battery pack is securely attached to the main unit.
  2. Turn on the vacuum cleaner by pressing the power trigger; press once for the minimum power setting, press twice to use the maximum power setting.
  3. To turn off the vacuum cleaner, press the power trigger again.

Warning: Do not use the vacuum cleaner without the HEPA filter and filter cone in position. The dust container must be closed before use. Clean the HEPA filter regularly to preserve the suction of the vacuum cleaner.

Using the Extension Tube and Floor Brush

The extension tube can be fitted onto the air inlet to extend reach, ideal for floor-to-ceiling cleaning.

  1. Fit the extension tube onto the air inlet by aligning the pins and carefully pushing the extension tube towards the main unit until it clicks into position. To release the extension tube, press the extension tube release button and pull it away from the vacuum cleaner main unit.
  2. Attach the floor brush by aligning the pins on the floor brush with the bottom of the extension tube. Carefully push together to secure into place. To release the floor brush, press the floor brush release button and pull it away from the extension tube.
  3. Turn on the vacuum cleaner by pressing the power trigger.

Using the 2 in 1 Crevice and Brush Tool

  1. If required, fit the extension tube onto the air inlet following the instructions in the section entitled 'Using the Extension Tube and Floor Brush'.
  2. Push the 2 in 1 crevice and brush tool onto the end of the extension tube. If no extension is required, push the crevice tool directly onto the air inlet until secure.
  3. Slide the brush bar back to use as a crevice tool, ideal for removing dust and dirt from corners and recesses. Slide the brush bar forward to use as a brush tool, perfect for cleaning upholstery and fabrics.
  4. To remove the 2 in 1 crevice and brush tool, pull it firmly away from the end of the extension tube or the air inlet.

Emptying the Dust Container

Before emptying the dust container, check that the vacuum cleaner is switched off and any attachments have been removed from the air inlet.

It is recommended to empty the dust container outdoors.

  1. Whilst securely holding the vacuum cleaner main unit, press the dust container base release latch. Empty the dust container slowly and carefully to reduce the amount of dust released back into the atmosphere.
  2. Close the dust container by pushing the base closed until the dust container base release latch locks back into position.

Note: Always close the dust container base before using the vacuum cleaner.

Cleaning the HEPA filter

The HEPA filter can only be accessed when the dust container is open.

  1. Open and empty the dust container following the instructions in the section entitled 'Emptying the Dust Container'.
  2. Once the dust container is empty, remove the filter cone by rotating it in an anticlockwise direction and lifting it out of the vacuum cleaner main unit.
  3. Carefully lift the HEPA filter out of the dust container. Shake the HEPA filter until the majority of the dust has been removed, then rinse under clean, warm water and allow to dry naturally.
  4. Once the HEPA filter is fully dry, place it back into the dust container. Replace the filter cone by aligning the indents on the filter cone with those on the top of the HEPA filter. Secure into place by rotating the filter cone in a clockwise direction.
  5. Close the dust container by pushing it firmly shut until it clicks into position.

Note: Do not clean the HEPA filter using detergents or use external heat sources such as radiators to dry them.

Warning: Do not reassemble or use the vacuum cleaner until the HEPA filter is fully dry, as this could cause damage.

Diagram showing steps for cleaning the HEPA filter: 1. Dust container open. 2. Removing filter cone. 3. Rinsing HEPA filter. 4. Replacing filter cone.

Cleaning the Floor Brush

The floor brush has a removable brush bar for easy cleaning.

  1. Switch off the vacuum cleaner and remove the floor brush by pressing the floor brush release button and pulling it away from the extension tube.
  2. Slide the brush bar release tab to release the brush bar and lift it out of the floor brush.
  3. Remove any built-up dust, debris and hair from the brush bar and floor brush.
  4. Replace the brush bar into the floor brush by aligning the tabs and sliding the brush bar release tab to the side, allowing the brush bar to fit into place.

Removing the Rechargeable Battery Pack

The battery pack can be removed from the vacuum cleaner main unit by pressing the battery release catch and sliding the battery pack out of the main unit. To refit the battery pack, re-align it with the main unit and press the release catch down whilst sliding the battery pack into place until it clicks.

Storage

Check that the vacuum cleaner is cool, clean and dry before storing in a cool, dry place. The vacuum cleaner can be neatly stored away after use by securing the main unit onto the extension tube using the storage hook.

Illustration of the Beldray Airgility Max cordless vacuum cleaner standing upright, showing how the main unit can be attached to the extension tube using the storage hook.

Troubleshooting

SymptomPossible CauseSolution
The vacuum cleaner will not charge.The mains power adaptor is not securely connected.Connect the mains power adaptor to the charging port on the battery, following the instructions in the section entitled 'Charging the Airgility Max Cordless.'
The battery is not fitted correctly.Fit the battery pack by aligning it with the main unit and sliding into place until it clicks.
The suction is poor.The air inlet is blocked.Disconnect the attachment and clear the blockage.
The dust container is almost full.Empty the dust container following the instructions in the section entitled 'Emptying the Dust Container'.
The HEPA filter is blocked.Clean the HEPA filter following the instructions in the section entitled 'Cleaning the HEPA Filter'.
The vacuum cleaner needs charging.Charge the vacuum cleaner following the instructions in the section entitled 'Charging the Airgility Max Cordless.'
The brush bar is not rotating.The brush bar is blocked due to built-up hair, dust and debris.Clean the floor brush following the instructions in the section entitled 'Cleaning the Floor Brush'.

Specifications

Manufacturer and Guarantee

Manufactured by: UP Global Sourcing UK Ltd., Victoria Street, Manchester OL9 0DD. UK.

For product issues or returns, contact the Customer Services Department at www.beldray.com or return to the retailer with your receipt.

Guarantee

All products carry a manufacturer's guarantee. Beldray provides a standard 12-month guarantee, subject to proof of purchase and use as instructed for domestic purposes. Misuse or dismantling invalidates the guarantee.

Damages from daily wear and tear, or consumables, are not covered.

Terms and conditions may be updated; check the website for the latest information.

This guarantee does not affect your statutory rights.

The crossed-out wheelie bin symbol indicates that this appliance should be disposed of in an environmentally friendly way. Contact your local authority for recycling details.

Extended Guarantee

*To be eligible for the extended guarantee, go to www.beldray.com and register your product within 30 days of purchase.

Rechargeable batteries are not included in the extended manufacturer's guarantee (after the first 12 months).

Find us on social media

Visit us on Facebook: www.facebook.com/Beldray

Manufactured by: UP Global Sourcing UK Ltd., Victoria Street, Manchester OL9 0DD. UK.

Website: www.beldray.com

©Beldray Trademark. All rights reserved.

Please retain instructions for future reference.

Made in China.

Models: cordless Powerful versatile vacuum cleaner

File Info : application/pdf, 14 Pages, 7.36MB

PDF preview unavailable. Download the PDF instead.

BEL0813NNEW Adobe InDesign 15.0 (Macintosh) Adobe PDF Library 15.0

Related Documents

PreviewBeldray Airgility Max Cordless Vacuum Cleaner Instruction Manual
Comprehensive instruction manual for the Beldray Airgility Max Cordless Vacuum Cleaner (BEL0813N), covering safety instructions, usage, maintenance, troubleshooting, and product specifications.
PreviewBeldray TURBOBOOST Cordless Vacuum Cleaner: Instruction Manual & Safety Guide
Comprehensive instruction manual for the Beldray TURBOBOOST Cordless Vacuum Cleaner (BEL01644), covering safety guidelines, operation, maintenance, troubleshooting, and specifications. Learn how to effectively use and care for your Beldray vacuum.
PreviewBeldray Clean & Dry Cordless All-in-One Wash & Vacuum Instruction Manual
Comprehensive instruction manual for the Beldray Clean & Dry Cordless all-in-one wash and vacuum solution (model BEL0908), covering safety guidelines, assembly, charging, operation, maintenance, troubleshooting, and warranty information for domestic use.
PreviewBeldray Airspire Cordless Vacuum Cleaner: Instruction Manual and Specifications
Comprehensive instruction manual for the Beldray Airspire Cordless Vacuum Cleaner, covering safety, usage, maintenance, troubleshooting, and specifications. Learn how to use and care for your vacuum.
PreviewBeldray Revo Cordless Vacuum Cleaner Instruction Manual
Comprehensive instruction manual for the Beldray Revo Cordless Vacuum Cleaner, covering safety, usage, maintenance, and troubleshooting.
PreviewBeldray BEL01981/BEL02005 Cordless Vacuum Cleaner User Manual
Comprehensive user manual for the Beldray BEL01981 and BEL02005 cordless vacuum cleaner, covering safety instructions, parts description, battery safety, usage, maintenance, troubleshooting, and specifications.
PreviewBeldray Pet Plus+ Multicyclonic Vacuum Cleaner Instruction Manual
Comprehensive instruction manual for the Beldray Pet Plus+ Multicyclonic vacuum cleaner (Model BEL0812NRG), covering safety, usage, maintenance, troubleshooting, and specifications. Designed for effective pet hair removal.
PreviewBeldray Quick Vac Lite Instruction Manual - User Guide
Comprehensive instruction manual for the Beldray Quick Vac Lite vacuum cleaner, covering safety, assembly, usage, maintenance, troubleshooting, specifications, and warranty. Learn how to use and care for your Beldray vacuum.