Getting Started
-
Attach Handle.
[Diagram: Illustrates attaching the handle to the main unit, with a 'click' sound indicated for secure connection.]
-
Fill Clean Water Tank with Water up to MAX line located on side of the tank.
[Diagram: Shows the clean water tank being filled with water, highlighting the MAX fill line on its side.]
-
Fill Solution Bottle with HOOVER Solution and slide into back of the unit.
[Diagram: Depicts filling the solution bottle with Hoover cleaning solution and then sliding it into the designated compartment at the rear of the unit.]
How to Use: Main Unit
-
Use pedals to operate.
[Diagram: Shows the main unit with operational controls, including 'On/Off' and 'Recline' levers, and foot pedals for activation.]
-
Slowly Push forward and squeeze trigger to wash. Release Trigger and slowly pull unit back to Dry carpet. Repeat and move to new section.
[Diagram: Demonstrates the cleaning motion. An arrow indicates forward movement with the trigger squeezed for washing. Another arrow shows backward movement with the trigger released for drying.]
How to Use: Above Floor
-
Hose Attachment.
[Diagram: Shows a hose being connected to the main unit's port.]
-
Tool Attachment.
[Diagram: Illustrates a specific cleaning tool being attached to the end of the hose for above-floor cleaning.]
-
Spray / Scrub.
[Diagram: Shows the attached tool in action, spraying cleaning solution and scrubbing a surface.]
How to Use: Cleaning and Maintaining
-
Remove Dirty Water Tank.
[Diagram: Shows the dirty water tank being detached from the main unit for emptying.]
-
Pull to Remove Nozzle Cover.
[Diagram: Illustrates pulling the nozzle cover away from the cleaning head.]
-
To Remove Brushes, press both tabs on side of foot. To Reinsert Brushes push them back in place until you hear a click.
[Diagram: Details the process of removing and reinserting the brushes by pressing side tabs on the unit's foot until a click is heard.]
-
Reinsert Brushes and Press Firmly until Latches Lock.
[Diagram: Shows the brushes being firmly pressed back into their housing until the locking latches engage.]
How to Use: Quick Clean Mode
-
To Engage Quick Clean Mode, Turn Knob Counter-Clockwise until engaged. Return to Deep Clean Mode by Turning knob Clockwise to Starting Position.
[Diagram: Shows a control knob on the unit. Arrows indicate turning the knob counter-clockwise to select 'Quick Clean Mode' and clockwise to return to 'Deep Clean Mode'.]
Additional Information
For Frequently Asked Questions and to Register your new product, scan here!
[Note: The original document contained a QR code linking to online resources and product registration. This QR code has been excluded as per instructions.]
