Hoover Power Scrub™ XL Carpet & Upholstery Cleaner
Quick Start Guide
Getting Started
Step 1: Attach Handle
Connect the handle components by aligning them and pushing until they click into place.
Step 2: Fill Clean Water Tank
Fill the clean water tank with water up to the MAX line indicated on the side of the tank.
Step 3: Fill Solution Bottle
Fill the solution bottle with Hoover Solution and slide it into the back of the unit.
How to Use: Main Unit
Step 1: Operate Pedals
Use the pedals to control the unit. One pedal is for On/Off, and another is for Recline.
Step 2: Wash and Dry Carpet
Slowly push the unit forward while squeezing the trigger to wash the carpet. Release the trigger and slowly pull the unit back to dry the carpet. Repeat this process for each section.
How to Use: Above Floor
Step 1: Hose Attachment
Attach the hose to the designated port on the cleaner unit.
Step 2: Tool Attachment
Attach the desired cleaning tool to the end of the hose.
Step 3: Spray / Scrub
Use the attached tool to spray cleaning solution and scrub the surface.
How to Use: Cleaning and Maintaining
Step 1: Remove Dirty Water Tank
Lift and remove the dirty water tank from the unit.
Step 2: Remove Nozzle Cover
Pull the nozzle cover to detach it from the unit.
Step 3: Remove Brushes
To remove the brushes, press both tabs located on the side of the brush foot.
Step 4: Reinsert Brushes
Push the brushes back into place until you hear an audible click. Press firmly until the latches lock securely.
How to Use: Quick Clean Mode
Engaging Modes
To engage Quick Clean Mode, turn the control knob counter-clockwise until it clicks into place. To return to Deep Clean Mode, turn the knob clockwise to its starting position.
