Caddx Infra V2 Quick Start Guide

Product Introduction

The Caddx Infra V2 is a night vision simulation camera with several key features:

• Reduced Size and Dimensions: Features a new optical design that reduces lens size while maintaining the same light intake as the Infra V1. It also uses a higher-grade AI processing chip to reduce the processor module size, making the device thinner and lighter.
• AI Image Enhancement: Equipped with a new generation AI night vision enhancement algorithm that improves image clarity by over 30% in low-light conditions. It also utilizes AI multi-frame algorithms to enhance the dynamic range during night vision, effectively suppressing overexposure/underexposure in backlit scenes and preserving full image details.

Installation Direction

Please install the camera with the indicated side facing down to ensure the image is not upside down.

Interface Definition and Connection

Interface Definition

The Infra V2 camera module has the following interfaces:

• Camera Port
• Power Port
• USB 2.0 Interface
• UART & GPIO

Power / CVBS Connection:

• POWER: Connect to FC solder pad (9-24V).
• GND: Connect to the GND.
• CVBS: Connect to the FC CAM interface.

UVC Connection Method and Output Function

After wiring the USB 2.0 interface according to the sequence shown, connect the computer to power the Infra V2 module. The computer can then read the camera image.

NTSC/PAL Switch Connection Method

To switch between NTSC (P mode) and PAL modes, short-circuit IO1A0 and GND for 1 second each time. The device will restart automatically after a mode switch. The default mode upon unpacking is P mode.

Specifications