Blue PURE FAN User Manual

Safety Instructions

Remember, the Blue Pure Fan is an electrical appliance. Please read these safety instructions carefully before use and take the necessary precautions to reduce the risk of fire, electric shock, or injury.

WARNING: Indicates a hazardous situation that, if not avoided, could result in death or serious injury.

CAUTION: Indicates a hazardous situation that, if not avoided, could result in minor or moderate injury.

General Cautions:

• Use the grounded power cable provided with your unit to plug directly into an appropriate, grounded electrical outlet. (Refer to the rating label on your unit)
• Do not alter the plug in any way.
• Always disconnect the power supply before servicing the unit.
• Do not use the unit if the power cable or plug is damaged or malfunctions in any manner.
• Keep the power cable away from heated surfaces.
• Do not sit on, stand, or climb onto the unit, or use the unit as a table or for storage.
• Do not place any objects on top of the unit, block air outlets or intakes, or allow foreign objects to enter the unit, as this may cause an electric shock or damage the unit.

Intended Use

• Supervise children to ensure that they do not play with the appliance.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. This Class B digital apparatus complies with Canadian ICES-003.

System Overview

The Blue Pure Fan is comprised of the following components:

• 1. Air outlet: The point where purified air exits the unit.
• 2. Air stream optimizer: Directs and enhances airflow.
• 3. Fan: The component that moves air through the unit.
• 4. Speed Control Button: Used to adjust fan speed and turn the unit on/off.
• 5. Motor: Powers the fan.
• 6. Fan holder: Supports the fan assembly.
• 7. Protective grill: Prevents access to the fan blades.
• 8. Release button for filter: Mechanism to access the filter compartment.
• 9. Pre-filter: A washable fabric layer that captures larger particles.
• 10. Particle filter: The main filter that captures fine particles.
• 11. Handle: For carrying the unit.
• 12. Air inlet: Where air enters the unit to be filtered.

What's in the Box

Your Blue Pure Fan package includes:

• The filter fan unit.
• Particle filter.
• Fabric pre-filter.

Options

• Choice of color and design for the fabric pre-filter is available.

Placement and Usage

Placement

Place the Blue Pure Fan in an upright position on the floor in your room. Ensure it is placed where it won't be easily knocked over by people or pets.

Using it in your bedroom:

After 7 seconds, the unit's light automatically dims.

Placing the unit:

• Place the unit in a location where air can circulate freely in, out, and around the unit.
• Do not place the unit closer than 10 cm (4 inches) from another object.
• Do not place the unit directly on or against soft furnishings such as bedding or linen.
• Do not place the unit near sources of heat, such as radiators, fireplaces, or ovens.
• Do not place the unit near wet areas, such as bathrooms or laundry rooms where it may come into contact with water.
• Do not place the unit outdoors.

Getting Started

Step 1: Plug in your unit.

Step 2: Turn on and set speed.

Press the speed control button once to turn the unit on and set it to low speed 1.

Step 3: Adjust speed to medium.

Press the speed control button twice to set it to medium speed 2.

Step 4: Adjust speed to high.

Press the speed control button three times to set it to high speed 3.

Step 5: Turn off the unit.

Press the speed control button a fourth time to turn the unit off.

The Blue Pure Fan features an Autostart function. This means the unit will automatically restart at the last set speed if a power failure occurs, the unit is unplugged, or a power switch timer is used.

Filters

General Information

The unit is delivered with two fabric pre-filters and one particle filter which removes the following pollutants:

• Particles
• Dust
• Pollen
• Pet dander
• Dust mites

Button Control Functions

Filter Replacement Indicator:

When the indicator light turns yellow (after approximately 5 months of operation), it is time to order a new filter.

Change Filter:

When the indicator light turns red (after an additional month of operation), you should change the main filter.

Reset Filter Alert:

Press and hold the button for three seconds to reset the filter alert after changing the filter.

You can change the filter before the indicator light turns red, i.e., when it first turns yellow. In this case, reset the unit after changing the filter and continue using it for another 6 months.

Vacuum or Wash the Pre-filter

Occasionally vacuum the exterior of the fabric pre-filter to remove dust. Before removing the fabric pre-filter, turn off and unplug the unit.

1. Gently press the release buttons on both sides of the unit until you hear a click.
2. Remove the back part of the unit.
3. Remove the main filter and pre-filter from the filter frame.
4. Carefully remove the fabric pre-filter from the main filter.
5. Wash the fabric pre-filter on a gentle, low-temperature cycle in the washing machine.
6. After washing the pre-filter, reverse this procedure (steps 4, 3, 2, and 1).
7. Plug in and turn on the unit.

Change the Main Filter

Be sure to unplug the unit before changing the main filter.

1. Gently press the release buttons on both sides of the unit until you hear a click.
2. Remove the back of the unit.
3. Remove the main filter from the filter frame.
4. Carefully detach the fabric pre-filter from the old main filter and attach it onto the new main filter.
5. Insert the new main filter back into the filter frame and lock into position.
6. Plug in the unit.
7. Restart the unit. Press the button for a duration of 5 seconds to re-set the unit.
8. This action informs the unit that the filter has been changed. The indicator light will flash for five seconds and then change from red to white.

General Care

Take good care of your filter fan to ensure it delivers optimal performance.

• Vacuum the pre-filter occasionally to remove dust, or wash it on a gentle, low-temperature cycle in the washing machine.
• Change the main filter every six months, depending on operating conditions. Remember to unplug the unit before changing the main filter.
• When the unit is open to change the filter, vacuum any dust that may have accumulated inside the unit.
• Occasionally wipe the top of the unit with a dry dust cloth.

Specifications

¹Certified ratings as stated are based on U.S. version models (120VAC, 60Hz) with particle filter. Ratings may be affected by use of other Blue filter models.

²The available electrical power voltage and frequency affects the power consumption of the unit. The power consumption might therefore be different from the stated value.

³Depending on air quality in the area of use, the recommended six-month filter lifetime may be longer.

Contact Information

For support and inquiries, please contact Blueair:

Blueair AB

Karlavägen 108
115 26 Stockholm
Sweden
Tel: +46 8 679 45 00
info@blueair.se

Blueair Inc.

125 S Clark
Suite 2000
Chicago, IL. 60603
USA
Tel: +1 888 258 3247
info@blueair.com

Blueair AB Middle East

Jafza One, Office No. AB1503
Jebel Ali Free Zone
P.O. Box No. 263947
Dubai, United Arab Emirates
Tel: +971 (4) 8821244
salesme@blueair.se

Blueair Asia Ltd.

Unit 8C, 8/F, MG Tower,
133 Hoi Bun Road,
Kwun Tong, Kowloon,
Hong Kong
Tel: +852 2345 8988
blueairasia@blueair.se

Blueair (Shanghai) Trading Co. Ltd.

Room 1001, City Gateway
No. 398 North Caoxi Road
Xuhui Distr, Shanghai,
China
Tel: 400 006 9693
info@blueair.cn

Blueair, Hindustan Unilever Limited (HUL)

Unilever House, B. D.
Sawant Marg, Chakala, Andheri (E),
Mumbai - 400 099
India
Tel: 1860-210-1000
blueair.hul@unilever.com

Website: www.blueair.com