Lemorele Wireless HD Transmitter & Receiver Kit

Preface

Thank you for purchasing the Lemorele product. For optimum operation, please read this manual carefully before use.

Connection Diagram

The diagram illustrates the connection setup for the Wireless HD Transmitter and Receiver Kit.

Transmitter: Features an HD Signal Port for connecting to the source device, a USB-C Power Port for power supply, and an Indicator Light.

Receiver: Features an HD Signal Port for connecting to the display device, a USB-C Power Port for power supply, and an Indicator Light.

The setup involves connecting the transmitter to the source device's HD port and the receiver to the display device's HD port, with both powered via USB-C.

Hardware Casting

This kit offers a combination of receiver and transmitter, designed for plug-and-play functionality.

The visual shows the transmitter connected to a source device (e.g., laptop) and the receiver connected to a display device (e.g., monitor or TV), with a wireless connection indicated between them.

Problem Solving

Q: How to restore factory settings?

A: When the product fails, press and hold the receiver function button for more than 5 seconds. The indicator will flash for pairing, and the transmitter indicator will be always on, indicating that the connection is successful.

Q: Can devices without HD interface be used?

A: Yes, please use the device with an HD interface converter.

Q: How to enter privacy mode?

A: Tap the transmitter function button to disconnect or reconnect.

Pairing Instructions

This product has been paired out of the factory. In case of pairing failure, or if other circumstances during use, it is necessary to re-cable and re-put the device as follows:

1. Connect the HD signal of the transmitter or receiver to the corresponding HD port.
2. Connect the USB-C power cable to the transmitter or receiver.
3. Press and hold the function button on the transmitter or receiver for 5 seconds until the indicator light flashes.
4. Press and hold the function button on the other device for 5 seconds until the indicator light flashes.
5. Wait for the indicator lights to become solid, indicating successful pairing.

Diagrams show the transmitter and receiver units with their respective ports and function buttons.

Safety Warning

Warning: Do not use the product in high humidity environments (such as bathrooms) to avoid water damage. ?