Lemorele R1000 Wireless HD Transmitter Receiver Kit

Product Introduction

This section introduces the components of the Lemorele Wireless HD Transmitter Receiver Kit.

Receiver (RX)

The Receiver unit features:

• [Antenna]
• [Indicator Light]
• [Function Button]
• [USB-C Power Supply Port]
• [HD Port]

Transmitter (TX)

The Transmitter unit features:

• [Antenna]
• [Indicator Light]
• [Function Button]
• [USB-C Power Supply Port]
• [HD Port]

Connection Diagram Description

The diagram illustrates the setup where a Transmitter (TX) is connected to a source device (e.g., computer), wirelessly transmitting a signal via [Wireless Signal] to a Receiver (RX). The Receiver (RX) is then connected to a display device (e.g., TV or monitor) via its [HD Port]. Multiple display devices can be connected to the receiver.

Connection and Usage

The kit is designed for plug-and-play use, combining the receiver and transmitter.

1. Connect the [HD Port] of the receiver to the video input port of a display device such as a monitor or TV.
2. Connect the [USB-C Power Supply Port] of the receiver to the charging cable and plug it into a power adapter or USB-C power source (Voltage above 5V, current above 2A).
3. Adjust the HD signal source of the monitor or TV to the corresponding HD port until the receiver's boot screen is displayed and the connection is successful.
4. Connect the transmitter to a computer or other devices with an HD video output function. After the indicator light enters the fast flash state, wait for ten seconds to complete casting.

Pairing Instructions

The product is paired at the factory. If pairing fails due to improper operation or other circumstances, follow these steps to restore and re-pair the device:

Transmitter Indicator Status:

• Always On: Connected
• Fast Flash: Pairing
• No connection/Fast Flash: Disconnected/Connected (Note: This seems to be a slight contradiction in the original text, interpreting as 'No connection' or 'Fast Flash' for pairing/connecting states)

1. Press and hold the receiver's function key for more than 5 seconds. The interface will display a message: "Pairing Timeout: 90S". Wait for the transmitter to enter pairing mode.
2. Press and hold the transmitter's function key for more than 5 seconds. The indicator light will flash quickly for pairing. Wait for the transmitter indicator light to remain on, indicating a successful connection.
3. After the first pairing is completed, pair the second, third, and fourth devices in the same way.

Function Settings

You can manage network settings, resolution, upgrades, and restarts via the device's web interface.

1. Search for the receiver in your wireless network. The network name is typically "TuTuLink-xxxx" and the default password is "12345678".
2. Open a web browser on your mobile device or tablet and enter the IP address 192.168.168.1 in the address bar.
3. Once the website loads, you can perform operations such as network distribution, resolution adjustment, firmware upgrades, and device restarts.

Mobile App Monitor

The diagram shows how to connect to the "TuTuLink" app. Download the "TuTuLink" app from Google Play or the App Store. Follow the on-screen instructions to complete the connection steps.

Note: The receiving distance of TuTuLink is approximately 20 meters.

Problem Solving

• Q: How to restore factory settings?
  A: If the product malfunctions, press and hold the receiver's function button for 15 seconds. After the screen goes black and restarts, the factory settings will be restored.
• Q: How to enter privacy mode?
  A: Briefly tap the transmitter's function button to disconnect or reconnect.
• Q: Can devices without an HD interface be used?
  A: Yes, you can. Please use the device with an HD interface converter.