Assembly Instruction

Important Safety Information

Inspect the bed before each use, ensure all components and parts are correctly and securely positioned. Do not use if any parts are worn, defective, or missing.

• Do not use sudden seating or bouncing on the bed.
• Do not jump onto or off the bed.
• Do not use the bed unless placed at a stable position.

When cleaning the bed, please use a leather cleaner.

Suggested tools: electronic screwdriver.

Parts Included

Hardware Included

Assembly Steps

Step 1: Assemble Slat Frame

Connect the slat frame with metal bars (O, P1, P2, Q) using fittings (I, J, L).

Step 1: Prepare Slats

Attach slat caps (K) to the ends of the slats. Connect slats with connectors (N) in the center. Gently press the caps onto the siderails of the slats frame.

Step 2: Install Slat Fasteners

Install part R to the slats using E screws (M8x25MM).

Step 3: Install Corner Codes

Install the corner codes (parts A, C) using hardware D, T, H, F, G, B.

Step 4: Install Plastic Feet

Install the plastic feet (parts F, H) to the base of the bed frame using hardware D, T, G.

Step 5: Attach Non-Woven Fabric

Attach the non-woven fabric (part 4) to the bed frame. The fabric has a sticky burr for easy attachment.

Step 6: Install Pneumatic Rod and Bending Rod

Install the pneumatic rod and bending rod (parts 5, 6) using hardware D, 1, 3, 6.

Step 7: Install Plain Codes

Install plain codes (parts 1, 3, 2) using hardware B, D.

Step 8: Slat Orientation

Orient the slats correctly: 'Headboard Direction' should face the headboard, and 'Footboard Direction' should face the footboard when installing into the pneumatic rod.

Step 9: Skeleton Installation

Install the skeleton of the bed frame.

Step 10: Fasten Rod

Fasten part S onto the rod using E screws (1, 3, 2).

Attention Points

1. Please use the bed after completely assembling it.
2. The Hydraulic part cannot be operated separately by hand; it must be assembled on the bed to function correctly.
3. Make sure the hydraulic part's silver part is on top and the green part is on the bottom.
4. Push HARD in the middle of the footboard of the frame, and the hydraulic will go down. Lift the frame if you want to use the storage area.