Pabobo Musical Stars Projector
Instruction Manual
What's Included
- Soft plush toy
- Stars Projector module
- Instruction manual
Getting Started
The projector uses small LEDs and requires no bulb.
Setup:
- Open the plush toy's back using the velcro® straps.
- Remove the Stars Projector module.
- Unscrew the battery compartment cover.
- Insert 3 AA LR6 batteries (not included), observing correct polarity. Do not use rechargeable batteries, as they may not provide sufficient power for both projection and music.
- Close and secure the battery compartment.
- Attach the two straps to the projector, ensuring the buttons face upwards. The straps have different widths to help position the projector correctly.
- Slide the projector's upper part (buttons up) into the opening at the back of the plush.
- Secure the straps firmly.
- Insert the projector's bottom part into the plush and fasten it with the round scratch closure. The projector is now ready.
Operation:
Two buttons, labeled (A) and (B), are located under the embroideries on the plush's back.
- Button (A): Press the embroideries to control the projector. A single press changes the projection color and turns the device on/off. Subsequent presses cycle through: start projections, freeze current color, resume color change. A long press (5 seconds) turns the projector off.
- Button (B): Controls the music. Press once to turn music on, twice to increase volume, and a third time to turn music off.
The projector automatically shuts off after 22 minutes of use (including 15 minutes of music).
Optimal Viewing:
- For the best projection experience, ensure the room is as dark as possible, with all other light sources turned off.
- Position the projector 1 to 3 meters away from walls and ceiling.
- Note: Projection brightness may decrease as battery power levels drop.
Diagram Description
The diagram illustrates how to attach the Pabobo Musical Stars Projector to the plush toy. It shows the projector module being secured to the back of the plush using two straps. The projector has two control buttons labeled 'A' and 'B' located on its upper surface. The diagram also indicates the location of the battery compartment and the correct orientation for inserting the projector into the plush.
Environment & Safety
Environment
Batteries contain components that are difficult to recycle. Please dispose of used batteries at designated collection points to protect the environment.
Safety Information
- This projection unit is designed for indoor use only and is not waterproof.
- Always clean the device with a dry cloth.
- Do not recharge non-rechargeable batteries.
- Do not mix different types of batteries, or new and used batteries.
- Ensure batteries are inserted with the correct polarity.
- Remove exhausted batteries from the product promptly.
- Avoid short-circuiting the power terminals.
- If the product malfunctions, do not attempt to dismantle it. Please contact customer service for assistance.
For customer support, visit: www.pabobo.com/en/help/contact
Plush Care
- Important: Before cleaning, remove the plastic projector module from the plush, even for superficial cleaning. Water ingress will cause the module to cease functioning and void the warranty.
- Hand wash or machine wash at 30°C is recommended.
- Tip: To preserve the plush's softness, place it inside a pillowcase before washing.
- After washing, shake the plush to redistribute the filling evenly.
- Warning: Do not tumble dry.
