Xiaomi Magnetic Reading Light Bar - User Manual

Product Information

Manufactured for: Xiaomi Communications Co., Ltd.

Manufacturer: FEIHUI Lighting Technology (Shanghai) Co., Ltd. (a Mi Ecosystem company)

Address: 2nd floor, No.9, Lane 888, Tianlin Road, Minhang District, Shanghai City, P.R. China

For further information, please visit: www.mi.com

User Manual Version: V1.0

Product Overview

Package Contents:

• Xiaomi Magnetic Reading Light Bar
• Base
• USB charging cable
• User manual
• Warranty notice

Specifications

Model: 9290041698

Color Temperature: 4000 K

Color Rendering Index: Ra90

Battery Capacity: 2000 mAh

Rated Input: 5 V 1 A

Rated Power: 5 W (0.03 W/LED module × 60)

Item Dimensions: 360 × 37 × 40 mm

Net Weight: Approx. 0.22 kg

Notes and Warnings

• ? indicates that the light bar is for indoor use only (operating temperature: 0°C to 40°C).
• Do not disassemble or repair the light bar yourself.
• To avoid potential safety risks and prevent damage to the light bar, do not use it near water or heat sources (e.g., radiator, heater, stove, humidifier, etc.). Never use it in humid conditions or cover it for a long period of time.
• The light source of this luminaire is not replaceable; when the light source reaches its end of life, the whole luminaire shall be replaced.
• Charge the light bar regularly when it is not in use for a long period of time. If it has not been used for a long time, the light bar must be charged for at least 30 minutes (while turned off) before use to prevent insufficient voltage that affects use. It takes approximately 4.5 hours to fully charge the light bar (while turned off), and it can last for approximately 4.5 hours at maximum brightness.
• The light bar contains a lithium-ion battery. Do not disassemble, puncture, crush, or throw the light bar, or expose it to fire. Do not place the light bar in a high-temperature environment. Do not use the light bar if it has been submerged in water.
• The adhesive strip on the base cannot be reused. Please confirm the positioning before adhering the base.
• Before adhering the base, please make sure your surface is smooth, clean, and dry. It is recommended to adhere the base to wooden or metal surfaces. Do not adhere it to a painted wall surface. The adhesive strip should be used at a temperature between 21°C and 38°C (pre-heating is recommended in temperatures below 10°C) to avoid affecting the adhesive effect.

How to Install

Follow these instructions to install the light bar:

1. Peel the release paper from the base 3M adhesive strip.
2. Stick the base to a smooth, clean, and dry surface by applying sufficient pressure, then leave it for 24 hours.
3. Attach the light bar to the base magnetically.

How to Use

Operation:

• Press: Turn on/off
• Press and hold: Adjust brightness (3 levels)

Charging:

• Connect the light bar to a power supply using the included USB charging cable.
• Charging: The indicator light stays red.
• Fully charged: The indicator light stays white.

Regulatory Compliance and Recycling Information

WEEE Disposal and Recycling Information:

All products bearing this symbol (♻️) are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed with unsorted household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the environment and human health.

Please contact the installer or local authorities for more information about the location as well as terms and conditions of such collection points.