FLORSJÖN Soap Dispenser Holder
Product Information
The FLORSJÖN is a soap dispenser holder designed and manufactured by IKEA of Sweden.
Article Number: 006.051.51 (as indicated in OCR data)
Maximum Weight Capacity: 4 kg (8.8 lb)
Important Note on Wall Mounting
As wall materials vary greatly, screws and wall fixings are not included with this product. It is crucial to use screws and fixings appropriate for your specific wall type (e.g., drywall, concrete, wood). For advice on suitable screw systems, please contact your local specialized dealer or hardware store.
Assembly Instructions
This section details the primary method for assembling and mounting the FLORSJÖN soap dispenser holder.
Required Tools (Not Included)
- Suitable screws and wall plugs for your wall type
- Spirit level
- Pencil
- Utility knife
- Pliers (for alternative methods)
Included Component
- Allen key (1x, part number 10144304)
Step 1: Prepare Product Body
Take the main product body. Use the provided Allen key (1x, part 10144304) to insert and tighten a screw into the designated hole on the product body. A warning symbol ❌ indicates that screw type 10119666 should not be used.
Step 2: Insert Component
Insert the small, circular component into the opening on the product body.
Step 3: Prepare Wall Mounting
Prepare two wall mounting plates. Use a spirit level, pencil, and utility knife to mark the desired position on the wall. Insert suitable wall plugs (not included) into the wall at the marked locations.
Step 4: Attach Mounting Plates
Attach the two mounting plates to the wall using appropriate screws (not included). Ensure they are securely fastened.
Step 5: Mount Product Body
Align the main product body with the wall-mounted plates and slide it into place.
Step 6: Secure Product Body
From the underside of the product, use the Allen key (1x, part 10144304) to tighten the screw, securing the product firmly to the wall mount.
Alternative Mounting Methods & Information
The following steps and information relate to alternative mounting methods or specific accessory components, potentially for different wall surfaces or related products like KROKSJÖN.
KROKSJÖN Mounting Information (ℹ️)
For specific KROKSJÖN mounting procedures:
- Wait 24 hours [⏳].
- Spray the wall surface (e.g., tile) with water.
- Wipe the surface clean.
- Attach the mounting component.
Cover Plate and Component Assembly
- Step 5: Cover Plate Operation Open the cover plate by lifting it. A warning symbol ❌ indicates an incorrect method of attachment or operation.
- Step 6: Wall Plate Attachment Warning A warning symbol ❌ indicates incorrect placement or attachment of the wall plate.
- Step 7: Assemble Components Assemble the two provided components.
- Step 8: Rotate Component Rotate the assembled component as indicated by the circular arrow [?].
- Step 9: Insert and Secure Insert the assembled component into the wall mount. A close-up shows a finger pressing a release mechanism [?] to secure it.
Finalizing Installation Steps
- Step 10: Trimming and Waiting Wait 24 hours [⏳]. Use a cutting tool (e.g., utility knife) to trim excess material. A close-up shows a correct trim [✔️] and an incorrect trim [❌].
- Step 11: Final Attachment Attach the main product body to the wall mount.
- Step 12: Final Tightening From the underside of the product, use the Allen key (1x, part 10144304) to tighten the screw, securing the product firmly to the wall mount.
Alternative Method: Pliers
- Step 3: Using Pliers Use pliers to grip and rotate the component as indicated by the arrow [➡️].
- Step 4: Attach Cover Attach the cover.
