KROKSJÖN Adhesive Wall Mounting Kit

How to Install

Follow these steps for a secure installation:

1. Surface Preparation

   Ensure the mounting surface is clean, dry, and free from dust, grease, and lime. For optimal adhesion, clean the surface thoroughly with isopropyl alcohol. Before applying the adhesive, wipe the surface with a lint-free cloth to ensure it is completely dry. Do not use cleaning products containing silicone.

2. Adhesive Application

   Apply the structural adhesive to the adapter. Note: The adapter is designed solely for applying adhesive and should not be used for drilling.

3. Mounting the Adapter

   Press the adapter firmly onto the prepared wall surface. Allow the adhesive to cure completely for 24 hours before attaching any accessories. This curing period is crucial for strong adhesion.

4. Attaching the Accessory

   Once the adhesive has fully cured, the accessory can be attached to the mounted adapter.

Diagram Key: The visual instructions illustrate the process from surface cleaning (1), adhesive application (2), adapter mounting (3-4), to accessory attachment (6-7), with a 24-hour curing period indicated (8).

Important Information

Suitable Surfaces: This product is designed for use on smooth, non-porous surfaces such as tiles, marble, glass, metal, stone, and concrete.

Unsuitable Surfaces: Do not use on wood, wallpaper, plasterboard, painted, varnished, or plastic wall materials. Using the product on these surfaces may cause damage when removing the accessory.

Handling Adhesive: Do not touch the adapter after applying the adhesive, as this may compromise its performance. Wait for the adhesive to fully cure before removing any excess adhesive from the adapter.

Safety Precautions:

• Keep out of reach of children.
• In case of contact with eyes: Rinse eyes immediately with plenty of water for several minutes.
• In case of contact with skin: Wash the affected area thoroughly with soap and water.
• If swallowed: Seek medical attention if any symptoms occur.

Product Details

Composition: Structural adhesive (silane-modified polymer, filler, additive, stabilizer, and catalyst).

Expiry Date: Refer to the expiry date printed on the adhesive applicator packaging (format: YYYY-MM-DD).

Storage: Store the adhesive in a dry location at a temperature between +5°C and +30°C. Protect from direct sunlight and do not store in unprotected outdoor areas.

Disposal

Dispose of the adhesive content at an authorized waste collection point or recycling center in accordance with local and national regulations. Empty packaging may be disposed of with regular household waste, following applicable regulations.

Removing the Accessory

To remove the adapter without damaging the wall surface: Use a wrench or similar tool to detach the adapter. Use a spatula or a similar tool to carefully remove any remaining adhesive residue.