Olight Valkyrie Turbo User Manual

Product Overview

The Valkyrie Turbo is a tactical flashlight designed for compatibility with Glock or Picatinny (MIL-STD-1913) rails. It comes with a "GL" adapter pre-installed, and a Picatinny adapter is included for mounting on Picatinny rails. The adapter can be swapped using the provided screws and wrench.

Compatibility Check:

• The Valkyrie Turbo can be used on most Glock or Picatinny (MIL-STD-1913) type rails.
• To install on Picatinny rails, replace the "GL" adapter with the included 1913 adapter using the provided screws and wrench.

Light Installation

Opening the Swing Arm: Pull open the swing arm as shown in the diagrams. Ensure the adapter fits inside your rail notch.

Closing the Swing Arm: Close the swing arm once it is aligned.

Before First Use

Battery Installation:

1. Open the tailcap by removing it.
2. Place the batteries inside the body, observing the polarity marks.
3. Hold the tailcap down firmly and close the spring lock.

Notice:

• Please pay attention to battery polarities during installation.
• The switches are better protected from drops when the product is properly mounted.
• At room temperature, the light will operate at its top output mode for 3.5 minutes and then gradually step down to 60 lumens within 0.5 minutes.
• Not compatible with RCR123A batteries.

How to Operate

• Constant On/Off: Single press either side of the tail switch for constant on. Press again to turn off.
• Momentary On: Press and hold either side of the tail switch for momentary illumination. Release the switch to turn off.
• Strobe: To enter strobe mode, press both sides of the tail switch and release, or press and hold one side then press the other and release. Press either side switch to turn off strobe mode.

Specifications

• Max Output: ≤0.35mW@455nm Wavelength (LASER 1)
• Waterproof: IPX6
• Impact Resistance: 1m
• Dimensions: 90.1*36.6*33.7mm / 3.55*1.44*1.33in
• Weight: 133g / 4.7oz (Including Batteries)
• Beam Distance: 530m
• Max Candela: 70,225cd
• Light Source: 530m (Beam Distance)
• Runtime: 250 lumens (High) for 4 minutes + 180 minutes (Low)
• Available Batteries: 2 x CR123A

*Results are based on tests using two 3V 1600mAh CR123A batteries, obeying ANSI/NEMA FL1 standard.

Warning

• Keep out of reach of children.
• The flashlight surface may reach 50°C or above when in use for extended periods. Avoid touching to prevent burns.
• DO NOT disassemble the product, as this may cause irreversible damage.
• If the product is unused, remove batteries and store them separately.
• LEP light is bright and blinding – DO NOT shine at aircraft or vehicles at any distance.
• DO NOT shine the light directly into human eyes, as this may cause temporary blindness or permanent damage.
• DO NOT cover the flashlight's head or place it on the ground when on. Radiation energy may damage the flashlight or cause nearby flammable objects to burn.
• DO NOT use the battery if its wrap is broken.

Danger

Complies with IEC 60825-1:2014 Class 1 and IEC 62471 Group 2. Report Number: 6818421136401. December 28, 2021.

CAUTION: Possibly hazardous optical radiation emitted from this product. Do not stare at operating lamp. May be harmful to the eyes. RISK GROUP 2

Exclusion Clause

Olight is not liable for damages or injuries sustained resulting from the usage of the product inconsistent with the warnings in the manual.

Warranty

• Within 30 days of purchase: Contact the original seller for repair or replacement.
• Within 5 years of purchase: Contact Olight for repair or replacement.

This warranty does not cover normal wear and tear, modifications, misuse, disintegrations, negligence, accidents, improper maintenance, or repair by anyone other than an authorized retailer or Olight itself.

Contact Information

USA Customer Support: cs@olightstore.com

Global Customer Support: customer-service@olightworld.com

Visit www.olightworld.com to see the complete product line of portable illumination tools.