Mondaine stop2go Watch Instruction Manual

Part 1: Aligning the Hands (Optional)

The watch hands are pre-aligned during production. However, you can easily realign them by following these steps:

1. Press and hold the push corrector with the "time setting pen" for a long push (4 seconds) to activate the hand aligning mode. The second hand will start moving.
2. To advance the second hand, perform a short single push on the push corrector. The second hand will move forward by 1/4 of a second. To advance the second hand by ten seconds, perform a double push. Continue adjusting the second hand until it is aligned with the 12 o'clock index.
3. Once the second hand is properly aligned, press and hold the push corrector for a long push to switch to the minute aligning mode. The minute hand will start moving.
4. To advance the minute hand, perform a short single push on the push corrector. The minute hand will move forward by 1/4 of a minute. To advance the minute hand by ten minutes, perform a double push. Continue adjusting the minute hand until it is aligned with the 12 o'clock index.
5. After aligning the minute hand, press and hold the push corrector for a long push to switch to the hour aligning mode. The hour hand will start moving.
6. To advance the hour hand, perform a short single push on the push corrector. The hour hand will move forward by 1/4 of an hour. To advance the hour hand by two hours, perform a double push. Continue adjusting the hour hand until it is properly aligned with the 12 o'clock index.
7. After aligning all three hands in the order described above, press and hold the push corrector for a long push to switch back to the time setting mode. You can then adjust the time as needed by following Part 2, Step 2.

Part 2: Setting the Time

1. Perform a short single push on the push corrector with the "time setting pen" to enter the hour time setting mode. The hour hand will start moving. Note that the setting mode is available only for 30 seconds if you do not interact with the watch.
2. To advance the hour hand, perform a short single push on the push corrector. The hour hand will move forward by one hour. To advance the hour hand by three hours, perform a double push.
3. Set the hour hand to the desired time by repeatedly pressing the push corrector until you reach the desired hour.
4. After setting the hour hand, press and hold the push corrector for a long push to switch to the minute setting mode while you are still in the setting mode. The minute hand will start moving.
5. To advance the minute hand, perform a short single push on the push corrector. The minute hand will move forward by one minute. To advance the minute hand by ten minutes, perform a double push.
6. Set the minute hand to the desired time by repeatedly pressing the push corrector until you reach the desired minute.
7. After setting the minute hand, perform a long push on the push corrector to exit the setting mode, or wait for 30 seconds.

Congratulations, you have successfully set the time on your watch!

Note: The 'time setting pen' is available for ordering online.

Important Safety Information

! WARNING

KEEP THE BATTERY OUT OF REACH OF CHILDREN. The battery can cause serious injuries if swallowed or placed inside any part of the body. Seek medical attention immediately.