LINDBYN Mirror Assembly Instructions

Important Information

As wall materials vary, screws for fixing to the wall are not included. For advice on suitable screw systems, contact your local specialised dealer.

Tools Required

Tools required for installation include a spirit level, pencil, and tape measure.

The diagram illustrates a common scenario of initial confusion with parts, followed by seeking assistance from IKEA.

Assembly Steps

Step 1: Measure and Mark

Measure 53 cm (21 inches) from a reference point. Use a spirit level to ensure the mounting points are horizontal. Mark two points on the wall with a pencil for the fixings. An alternative measurement of 51.5 cm (20 1/4 inches) may also be used depending on desired placement or orientation.

Step 2: Prepare Wall Fixings

Insert screws into wall plugs. Ensure the correct type of wall plug and screw are used for your wall material. A '[stop symbol]' indicates caution; do not proceed if unsure about the fixings.

Step 3: Hang the Mirror

Align the mirror's mounting brackets with the prepared wall fixings and carefully hang the mirror.

Step 4: Adjust and Secure

Use a spirit level to ensure the mirror is straight. The magnified views show how to adjust and tighten the mounting hardware to secure the mirror in place.