Hikvision DS-KV6113-WPE1(C) Video Intercom Villa Door Station

1 Appearance

The Hikvision DS-KV6113-PE1(C) and DS-KV6113-WPE1(C) villa door stations feature a microphone, camera, loudspeaker, terminals, a debugging port, a TAMPER switch, a TF card slot, and a network interface. An indicator light shows the device status (Unlock: Green, Call: Orange, Communicate: White).

2 Terminal and Wiring

The terminals include connections for power input (12 VDC IN, GND), door lock relay output (NC, NO, COM), access for door contact (AIN1), access for exit button (AIN3), and reserved ports (AIN2, AIN4, RS-485+ and RS-485-). A diagram illustrates the wiring for these terminals.

3 Installation Accessory

The installation accessory includes a mounting template and a mounting plate. The mounting plate dimensions are 102.58 mm x 39.24 mm x 6.2 mm.

4 Installation

The door station supports surface mounting. It can be installed with or without a protective shield.

Surface Mounting without Protective Shield

1. Stick the mounting template on the wall and drill screw holes.
2. Secure the mounting plate to the wall using the supplied screws.
3. Install the villa door station onto the mounting plate and fix it with the set screw.
4. Apply silicone sealant around the cable wiring area to prevent water ingress.

Surface Mounting with Protective Shield

1. Stick the mounting template on the wall and drill screw holes.
2. Align the protective shield with the mounting template.
3. Secure the mounting plate and protective shield to the wall with screws.
4. Install the villa door station onto the mounting plate and fix it with the set screw.

Note: It is recommended to install the device with a protective shield when installing outdoors.

Recommended Installation Height: The distance between the camera and the ground should be between 1.4 m and 1.6 m.

5 Configuration via Web

1 Activate Device via Web

Before using the device, it must be activated by setting a strong password. The default IP address is 192.0.0.65, port is 8000, and username is 'admin'.

1. Power on the device and connect it to the network.
2. Enter the IP address into a web browser to access the activation page.
3. Set and confirm a strong password.
4. Click OK to activate the device.

Note: The computer and the device must be on the same subnet for activation.

2 Access the Device via Web Browsers

1. Enter the device's IP address into the browser's address bar and press Enter.
2. Enter the username and password, then click Login.

3 Communicate with Indoor Station

1. Navigate to Settings > Intercom > Press Button to Call.
2. Configure call numbers for each button and optionally set a Call Management Center.
3. Press the button to call the indoor station.

4 Issue Card

1. Navigate to Settings > Access Control and Elevator Control.
2. Click Issue Card and present the card to the card reading area.

Note: Only M1 cards are supported. Up to 10,000 cards can be managed. A voice prompt will indicate if the card limit is reached.

5 Unlock Door

After issuing cards, the door can be unlocked by presenting the issued cards.

For more details, refer to the Video Intercom Villa Door Station User Manual by scanning the QR code.