Taurus MCL300 Textile Care
Product Description
The Taurus MCL300 is a textile care device designed to remove lint and fuzz from fabrics, helping to refresh and maintain clothing and upholstery.
Key Components
- A: Power cord
- B: On/off button
- C: Dust container
- D: LED light
- E: Brush (rotating)
- F: UV-C ultraviolet light
- G: Center wheel
Instructions for Use
Before each use, fully extend the power cord.
Ensure all accessories are properly attached and in good condition. Do not use if accessories are defective.
This appliance is for dry use only. Do not use it to collect water or any other liquid.
Keep the appliance out of reach of children and individuals with reduced physical, sensory, or mental capabilities, or those lacking experience.
Avoid operating in areas with metal objects like nails or screws. Never vacuum hot or sharp objects such as cigarette butts, ashes, or nails.
Do not use on pets or animals.
To operate:
- Extend the power cord completely before plugging in.
- Plug the appliance into the mains.
- Place the appliance on the item to be cleaned (e.g., mattresses, sofas).
- Switch on the unit by pressing the on/off button (B).
- It is recommended to vacuum for at least 20 seconds per meter of fabric.
- To stop the appliance, press the on/off button (B) again.
After Use
- Unplug the appliance from the mains.
- Allow the appliance to cool down before cleaning.
Cleaning the Appliance
- Clean the unit with a damp cloth slightly moistened with detergent, then wipe dry.
- Do not use solvents, acidic or alkaline pH products (like bleach), or abrasive cleaners.
- Prevent water or other liquids from entering the ventilation openings to avoid damage to internal parts.
- Do not immerse the appliance in water or any other liquid, or place it under a tap.
Emptying the Dust Container
Empty the dust container after each use or when suction power significantly decreases.
- Remove the dust container by turning it counterclockwise (refer to Fig. 1).
- Dispose of the contents in a suitable waste container.
Removing the Brush
Pull the locking buckle of the rotating brush outwards in the direction of the arrow and lift it upwards (refer to Fig. 2).
After cleaning, re-engage the locking buckle and reinstall the rotating brush.
Filter Maintenance
The appliance uses a HEPA type filter, which effectively traps spores, ashes, mites, and pollen. It is recommended to check the filter's condition periodically.
The filter should be cleaned or replaced every 50 hours of use, or if a significant decrease in suction power is observed.
To Remove Filters:
- Remove the dust container as described in the "Emptying the Dust Container" section.
- Remove the lower cover and turn the filter counterclockwise.
- Wash the filter with soap and water. Dry thoroughly before reinserting.
- To reassemble the filter, follow the previous steps in reverse order.
Consumables
Consumable items, such as filters, can be purchased from the official Taurus website. Always use original consumables specifically designed for your appliance model.
Warranty and Technical Assistance
For warranty and technical assistance, please visit the official Taurus website: http://taurus-home.com/. You can also find related information and download the manual and its updates from this site.
Contact Information
For specific inquiries, please refer to the contact details provided at the end of the manual or on the Taurus website.
Taurus
