Xiaomi Redmi A2 2/32GB Quick Start Guide

This guide provides essential information for setting up and using your Xiaomi Redmi A2.

Getting Started

Long press the power button to turn on the device. Follow the on-screen instructions to configure your device.

For more detailed information, visit the official website: www.mi.com/global/service/userguide

About SIM

Please do not insert non-standard SIM cards into the SIM card slot, as they may damage the slot.

WARNING: Do not disassemble this device.

WEEE (Waste Electrical and Electronic Equipment)

Special precautions must be taken to safely dispose of this product. This marking indicates that this product may not be discarded with other household waste in the EU. To prevent harm to the environment or human health from inappropriate waste disposal, and to promote sustainable reuse of material resources, please recycle responsibly. To safely recycle your device, please use return and collection systems or contact the retailer where the device was originally purchased.

Important Safety Information

Read all safety information below before using your device:

Use of unauthorized cables, power adapters, or batteries can cause fire, explosion, electric shock, or damage to the device.
The device's operating temperature range is 0°C to 40°C. Using the device outside this range may damage it.
If your device has a built-in battery, do not attempt to replace it yourself.
Charge the device only with the included or authorized cable and power adapter. Use only authorized accessories compatible with your device.
After charging, disconnect the adapter from both the device and the power outlet. Do not charge the device for more than 12 hours.
The battery must be recycled or disposed of separately from household waste. Mishandling the battery may cause fire or explosion. Dispose of or recycle the device, its battery, and accessories according to your local regulations.
Do not disassemble, hit, crush, or burn the battery. If the battery appears deformed or damaged, stop using it immediately.
Do not short circuit the battery, as this may cause overheating, burns, or other injury.
Do not place the battery in a high-temperature environment. Overheating may cause explosion.
Do not disassemble, hit, or crush the battery, as this may cause it to leak, overheat, or explode.
Do not burn the battery, as this may cause fire or explosion.
Users shall not remove or alter the battery. Removal or repair of the battery shall only be done by an authorized repair center of the manufacturer.
Keep your device dry.
Do not try to repair the device yourself. If any part of the device does not work properly, contact Mi customer support or bring your device to an authorized repair center.
Connect other devices according to their instruction manuals. Do not connect incompatible devices to this device.
For AC/DC adapters, the socket-outlet shall be installed near the equipment and shall be easily accessible.

Safety Precautions

Observe all applicable laws and rules restricting use of mobile phones in specific situations and environments.
Do not use your phone at petrol stations or in any explosive atmosphere or potentially explosive environment, including fueling areas, below decks on boats, fuel or chemical transfer or storage facilities, or areas where the air may contain chemicals or particles such as grain, dust, or metal powders. Obey all posted signs to turn off wireless devices such as your phone or other radio equipment. Turn off your mobile phone or wireless device when in a blasting area or in areas requiring "two-way radios" or "electronic devices" to be turned off to prevent potential hazards.
Do not use your phone in hospital operating rooms, emergency rooms, or intensive care units. Always comply with all rules and regulations of hospitals and health centers. If you have a medical device, please consult your doctor and the device manufacturer to determine whether your phone may interfere with the device's operation. To avoid potential interference with a pacemaker, always maintain a minimum distance of 15 cm between your mobile phone and the pacemaker. This can be done by using your phone on the ear opposite to your pacemaker and not carrying your phone in a breast pocket. To avoid interference with medical equipment, do not use your phone near hearing aids, cochlear implants, or other similar devices.
Observe all aircraft safety regulations and turn off your phone on board aircraft when required.
When driving a vehicle, use your phone in accordance with relevant traffic laws and regulations.
To avoid being struck by lightning, do not use your phone outdoors during thunderstorms.
Do not use your phone to make calls while it is charging.
Do not use your phone in places with high humidity, such as bathrooms. Doing so may result in electric shock, injury, fire, and charger damage.

Security Statement

Please update your phone's operating system using the built-in software update feature, or visit any of our authorized service outlets. Updating software through other means may damage the device or result in data loss, security issues, and other risks.

EU Regulations

RED Declaration of Conformity

Xiaomi Communications Co., Ltd. hereby declares that this GSM / GPRS / EDGE / UMTS / LTE Digital Mobile Phone with Bluetooth and Wi-Fi 23028RN4DG is in compliance with the essential requirements and other relevant provisions of the RE Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.mi.com/en/certification

RF Exposure Information (SAR)

This device is in compliance with Specific Absorption Rate (SAR) limits for general population/uncontrolled exposure (Localized 10-gram SAR for head and trunk, limit: 2.0W/kg) specified in Council Recommendation 1999/519/EC, ICNIRP Guidelines, and RED (Directive 2014/53/EU).

During SAR testing, this device was set to transmit at its highest certified power level in all tested frequency bands and placed in positions that simulate RF exposure during use against the head with no separation and near the body with a separation of 5 mm.

SAR compliance for body operation is based on a separation distance of 5 mm between the unit and the human body. This device should be carried at least 5 mm away from the body to ensure RF exposure level is compliant or lower than the reported level. When attaching the device near the body, a belt clip or holster should be used which does not contain metallic components and allows a separation of at least 5 mm to be maintained between the device and the body. RF exposure compliance was not tested or certified with any accessory containing metal worn on the body, and use of such an accessory should be avoided. Any accessory used with this device for body-worn operation must keep the device a minimum of 1.5 cm away from the body.

Certification Information (Highest SAR)

SAR 10 g limit: 2.0 W/Kg, SAR Value: Head: 0.897 W/Kg, Body: 0.997 W/Kg (5 mm distance).

Legal Information

Observe national and local regulations where the device is used. Usability of this device may be restricted depending on the network provider. Restrictions in the 2.4 GHz band: Norway: This subsection does not apply for the geographical area within a radius of 20 km from the centre of Ny-Ålesund.

Ensure the power adapter used meets the requirements of Clause 6.4.5 in IEC/EN 62368-1 and has been tested and approved according to national or local standards.

Frequency Bands and Power

This mobile phone offers the following frequency bands in EU and UK only and maximum radio-frequency power:

GSM 900: 35.5 dBm
GSM 1800: 32.5 dBm
WCDMA band 1/8: 25.7 dBm
LTE band 1/3/7/8/20/28/38/40/41: 25.7 dBm
Bluetooth: 20 dBm
Wi-Fi 2.4 GHz band: 20 dBm

E-label

This device has an electronic label for certification information. To access it, please go to Settings > About phone > Certification, or open Settings and type "Certification” into the search bar.

Model Information

Model: 23028RN4DG

2302 indicates that this product will be launched after 202302.

Disclaimer

This user guide is published by Xiaomi or its local affiliated company. Improvements and changes to this user guide necessitated by typographical errors, inaccuracies of current information, or improvements to programs and/or equipment, may be made by Xiaomi at any time and without notice. Such changes will, however, be incorporated into new online editions of the user guide (please see details at www.mi.com/global/service/userguide). All illustrations are for illustration purposes only and may not accurately depict the actual device.

Manufacturer Information

Manufacturer: Xiaomi Communications Co., Ltd.

Manufacturer postal address: #019, 9th Floor, Building 6, 33 Xi'erqi Middle Road, Haidian District, Beijing, China, 100085

Brand: Redmi