Regulatory Information
Industry Canada Statement
[For products with wireless function (WLAN, Bluetooth)]
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
CAN ICES-003(B) / NMB-003(B)
IC Radiation Exposure Statement
[For products with wireless function (WLAN, Bluetooth)]
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm (7.8 inches) between the antenna and your body.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
WARNING [For products using 5 GHz frequency bands]
i. Devices operating in the 5150-5250 MHz band are for indoor use only to reduce potential harmful interference to co-channel mobile satellite systems.
ii. For devices with detachable antennas, the maximum antenna gain permitted for devices in the 5250-5350 MHz and 5470-5725 MHz bands shall comply with the e.i.r.p. limit.
iii. For devices with detachable antennas, the maximum antenna gain permitted for devices in the 5725-5850 MHz band shall comply with the e.i.r.p. limits as appropriate.
iv. [For devices operating in the 5250-5350 MHz band with an e.i.r.p. greater than 200 mW] Antenna type(s), antenna model(s), and worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 of RSS-247 shall be clearly indicated.
Users should also be advised that high-power radars are allocated as primary users of the bands 5250-5350 MHz and 5650-5850 MHz, and these radars could cause interference and/or damage to LE-LAN devices.
Installation and Usage
Please read this manual carefully before operating your set and retain it for future reference. For advanced features, visit http://www.lg.com. Some content may differ from your product.
Components:
- A: Sound bar
- B: Function LED / Remote Control Receiver
- C: Wireless Subwoofer - Install it close to the sound bar.
- D: External Device - (e.g., Blu-ray player, game console, etc.)
Connections:
1. Connect the sound bar to your TV via an optical cable.
2. If using an external device (e.g., Blu-ray player, game console), connect it to the TV via an HDMI cable.
3. Connect power in the following order: wireless subwoofer, then sound bar. Turn on the sound bar. The LED on the wireless subwoofer will light up green when the connection is automatically established.
Using the Product with Your TV:
1. Press the [F Button] repeatedly or the [OPTICAL Button] once until the Optical LED appears on the function LED.
2. In your TV's settings, set the audio output speaker to [Optical] or [External Speaker].
Connecting to Your Smartphone via Bluetooth:
1. On your smartphone, tap the Settings button and select Bluetooth. Turn on the Bluetooth function ([Off] > [On]).
2. Press the [F Button] repeatedly until the blinking Bluetooth LED appears on the function LED.
3. Find and tap the product on your smartphone. The product appears as "LG SQC1 (XX)".
4. When the product is connected to your smartphone via Bluetooth, the Bluetooth LED turns on.
Troubleshooting Wireless Subwoofer Connection:
If you see a red LED on the back of the wireless subwoofer, it means the sound bar is not connected to the subwoofer. Connect them in the following order:
- Press the [Power Button] on the sound bar to turn it off.
- Press the [Pairing Button] on the back of the disconnected wireless subwoofer. Check if the LED blinks green. If the LED is still red, press and hold the button on the back of the subwoofer again.
- Press the [Power Button] on the sound bar to turn it on.
- When the connection is established, the LED on the back of the wireless subwoofer will turn green.
Important Notes:
Keep the sound bar and subwoofer at least 1 meter (3.3 ft) away from devices like wireless routers or microwave ovens to prevent wireless interference.
Design and specifications are subject to change without notice.
Specifications
| Feature | Details |
|---|---|
| Power consumption | Refer to the main label. |
| AC adapter |
|
| Dimensions (W x H x D) | Approx. 660.0 mm x 56.0 mm x 99.0 mm (26.0 inch x 2.2 inch x 3.9 inch) |
| Bus Power Supply (USB) | 5 V ⎓ 500 mA |
| Amplifier (Total RMS Output power) | 160 W RMS |
Contact and Registration
LG Customer Information Center
Phone: 1-888-542-2623 (CANADA)
Register your product online at: www.lg.com
