ThermElc TE-02 PRO TH Temperature and Humidity Data Logger User Manual

Product Introduction

The ThermElc TE-02 PRO TH is designed for monitoring the temperature and humidity of sensitive goods during storage and transportation. It features USB and Plug-N-Play capabilities, allowing for automatic generation of secure PDF and CSV reports without the need for additional hardware or software. The TE-02 Pro TH data loggers are equipped with a high-precision sensor offering an accuracy of ±0.5°C across the entire range of -30°C to +60°C and ±3% rH.

Main Features

• Reusable temperature and humidity logger
• Automatic PDF report generation
• Automatic CSV report generation
• Logging of 32,000 points
• No special device driver required
• Temperature and humidity over-limit alarm
• Intuitive LCD Screen

Key Components: Start/Stop Button, LED Light, USB Cap, Battery Replacement Cap.

Specifications of ThermElc TE-02 PRO TH

Validation Certificate Hard Copy Included.

First Time Set Up

1. Open your Internet browser and navigate to thermelc.com. Click on 'Manuals & Software' in the menu bar.
2. Select the appropriate software for your model by clicking the download link or model picture.
3. Download and install the software by clicking the downloaded file and following the on-screen instructions.
4. Access the Temperature Management Software via the desktop shortcut after installation.
5. For full video instructions, visit youtube.com/@thermelc2389 and click on 'Playlists - How to use your ThermELC Data logger'.

Quick Start

1. Download the software from https://www.thermelc.com/pages/download and configure your parameters.
2. Press and hold the Start button for 3 seconds to begin recording.
3. Monitor measurements.
4. Connect the data logger to a PC via USB to read reports (PDF & CSV).

Operation Functions

1. Start Recording: Press and hold the START button for approximately 3 seconds. The OK light will illuminate, and the screen will display (►) or (WAIT) to indicate the logger has started.
2. Mark Data: While recording, press and hold the START button for over 3 seconds. The screen will switch to the 'MARK' interface, and the MARK count will increase, confirming data marking.
3. Stop Recording: Press and hold the STOP button for over 3 seconds until the STOP (■) symbol appears on the screen.
4. Switch Display: Briefly press the START button to cycle through display interfaces: Real-time Temperature, Real-time Humidity, LOG, MARK, Temperature Upper Limit, Temperature Lower Limit, Humidity Upper Limit, Humidity Lower Limit.
5. Get Report: Connect the data logger to a PC via USB to automatically generate PDF and CSV reports.

LCD Display Instructions

The LCD screen displays various statuses:

• Start/Stop: Indicates if the logger is recording or has stopped.
• Battery Status: Shows the current battery level.
• Alarm Status: Indicates if an alarm condition (high/low limits exceeded) is active.
• Start Delay: Shows if the logger is in a delayed start state.
• Log/Mark: Indicates logging and data marking status.
• Data Value: Displays the current temperature or humidity reading.
• Temperature/Humidity Scale: Shows the units (°C or %rH).

Status Indicators:

• WAIT: Data logger is recording.
• WAIT: Data logger has stopped recording.
• WAIT: Data logger is in Start Delay status.
• ✓: Temperature and Humidity are within the limited range.
• X and ↑: Measured value exceeds its upper limit.
• X and ↓: Measured value exceeds its lower limit.

Battery Replacement

Follow these steps to replace the battery:

1. Open the battery compartment.
2. Replace the CR2032 battery.
3. Close the compartment.

Technical Support

For technical support or video instructions, please visit:

• Website: https://www.thermelc.com
• Email: sales@thermelc.com
• Phone: +44 (0)207 1939 488