Onn. Bluetooth® Boombox

Specifications

• Frequency Response: 85Hz-20KHz
• S/N Ratio: ≥62dB
• Output Power: 2.5W*2 (RMS)
• Speaker: 3"*2

Inside Package

• Speaker: 1pc
• Aux Cable: 1pc
• Charging line: 1pc
• User Manual: 1pc

Caution

1. Do not expose to dripping or splashing.
2. Do not place any objects filled with water over the apparatus.
3. Do not block the ventilation holes.
4. When using high output signal, don't turn the volume to maximum to avoid distortion.

How to use the Bluetooth

1. Select the audio input to Bluetooth status.
2. Search Bluetooth device with name "ENKOR ET15".
3. Connect the Bluetooth.
4. If your Bluetooth device is below 2.0 version, input password "0000" when connecting.

Front panel

Button Functions:

• M: Short press to switch among AUX/FM/Bluetooth mode; Long press to power switch.
• Previous/Next: Previous song when Bluetooth input; Short press to previous channel when radio input; Long press to search backward for the previous channel when radio input.
• Play/Pause: Short press to Play/Pause song when AUX/Bluetooth input; Long press to disconnect connected devices and quickly pair when Bluetooth input; Long press to automatically search and save radio station when radio input.
• Next/Previous: Short press to next song when Bluetooth input; Long press to TWS pairing when Bluetooth input; Short press to next channel when radio input; Long press to search backward for the next channel when radio input.
• Volume Down: -
• Volume Up: +

What mean of the light

• Blue light means Bluetooth mode (The light flashing is in Bluetooth pairing status).
• Red light means AUX/FM mode (The light flashes during automatic channel search).
• Red light breathing means low power.
• Red light means charging.
• Green light means full charge.

System connection diagram

Connections:

• DC Input: DC 5V
• AUX Input
• FM Antenna

Timing alarm

How to use the alarm

• Enter the AUX mode, long press the II button to set the timing mode (the red light flashes).
• In the timing mode, short press the II button to select timed alarm (1 hour, 2, 3... 4 hours).
• Alarm setting confirmation: long press the II button to confirm completion and exit (The red light stops flashing and becomes normally on).

Note: The timing alarm is a one-time setting and does not repeat. If it is turned off, the timing alarm will be automatically cancelled.

DEAR CUSTOMER

Congratulations on your purchase! Please read this manual carefully and keep it for future reference.

FCC Caution

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Note

Do not leave objects generating magnetism near the speakers.