SUNCO LIGHTING

COMPONENTS

IC Rated Junction Box

EASY INSTALLATION

1. Turn off circuit breaker that provides power to the light switch for the recessed lights.

   [Power Switch] Turn Power OFF

2. Cut a hole in the ceiling in the desired location accordingly to the dimension indicated.

   Diagram: Hand measuring a 6.30 inch diameter hole in a ceiling.

3. Run electrical wire from the power source (switch) through the mounting hole.

   Diagram: Electrical wire being fed through a hole.

4. Open the junction box and remove the appropriate knockout(s) on the side plate.

   Diagram: Junction box with a circular knockout being removed.

5. Connect the supply wires to the junction box wires using the wire nuts provided.

   Diagram: Wire connections inside the junction box using wire nuts. Connect White to white and Black to black.

6. Tuck the connected wires inside the junction box and close the cover.

   Diagram: Wires neatly placed inside the junction box.

7. Connect the junction box to the slim down light. Tighten the connector by hand.

   Diagram: Junction box connected to the slim LED light fixture.

8. Turn on power and test light.

   BEFORE PROCEEDING:

   On the back of the junction box, slide the CCT Selection Switch to choose from five color temperatures (2700K, 3000K, 3500K, 4000K, 5000K). Try each CCT to determine which suits your room.

   The light will use the preferred setting whenever you turn on the switch.

   Turn off the light switch and continue the installation.

   Diagram: LED light fixture with a CCT selection switch on the back of the junction box.

9. Insert junction box through the hole in the ceiling.

   Notes for new construction applications: Hardwire box shall be secured to studs, joists, or similar fixed structural units.

   Notes for remodel applications: Do not require the hardwire box to be firmly secured after the mounting plates, studs, joists, or structural units have been concealed.

   Diagram: Junction box being inserted into the ceiling.

10. Push up the spring clips to insert the luminaire in the opening in the ceiling.

    Diagram: Spring clips on the LED fixture engaging with the ceiling.

11. Turn on circuit breaker and test the light.

WARNING

To reduce the risk of fire, electric shock or injury to people:

• This product should be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
• Abide by related regional and local laws or regulations.
• Do not alter, relocate or remove wiring.
• Do not make or alter any open holes in enclosure or electrical components.
• Proper grounding is required to ensure safety.
• Check for damage during shipping prior to install. If the product is damaged, do not use it.
• Turn off the switch and circuit breaker before installing this LED light.
• Use safety precautions. Safety eyeglasses and gloves are recommended.
• Please review instructions carefully before proceeding.

SPECIFICATIONS