Aquatec® Ocean Accessory Headrest Mounting Instructions
Product Code: 1470790
Compatible Models:
- Ocean Ergo
- Ocean VIP / Ocean VIP Ergo
- Ocean Dual VIP / Ocean Dual VIP Ergo
- Ocean E-VIP
Ocean Ergo Headrest Assembly
Part Number: AP1606985
The following diagram illustrates the components included for the Ocean Ergo headrest assembly:
A diagram shows the headrest component with its curved support arms, along with several screws and washers.
Mounting Procedure
Follow these steps to mount the headrest accessory:
1.Attach the clamp mechanism to the horizontal bar of the shower chair. An arrow indicates insertion of the clamp. A hand-tightened knob is visible for securing.
Illustration shows a clamp with a star-shaped knob being attached to a tube.
2.Position the second clamp mechanism on the horizontal bar and insert it. An arrow indicates the direction of insertion.
Illustration shows a square-shaped fitting being inserted into a clamp on a tube.
3.Lower the main arm of the headrest assembly into the mounted clamp. An arrow indicates the downward motion.
Illustration shows the vertical arm of the headrest assembly being inserted into the clamp.
4.Secure the arm by rotating the knob on the clamp mechanism. A curved arrow indicates the direction of rotation.
Illustration shows a star-shaped knob being turned to tighten the clamp.
5.Adjust the headrest mounting bracket.
Close-up view of the headrest bracket showing adjustment mechanism.
6.Slide the bracket to the desired position. Arrows indicate the sliding direction.
Illustration shows the bracket sliding horizontally along a rail.
7.Tighten the knob on the headrest mounting bracket to secure the position. A curved arrow indicates rotation.
Illustration shows a star-shaped knob being turned to lock the headrest bracket.
Manufacturer: Invacare GmbH
Address: Am Achener Hof 8, D-88316 Isny, Germany
Document Reference: 1639496-B
Date: 2021-09-06
Page: 1/1
Compliance Mark: CE ℹ️
