Aquatec® Ocean Accessory: Front Antitipper
Mounting Instructions for Ocean Ergo and Ocean Ergo XL
Product Information
This document provides instructions for mounting the Front Antitipper accessory onto Aquatec Ocean Ergo and Aquatec Ocean Ergo XL models.
Accessory Model Number: AP1601986
Parts Included
The following components are included with the Front Antitipper accessory:
- Curved metal tube: 2x
- Straight metal pin: 4x
- Nuts: 4x
- Washers: 8x
- Mounting brackets: 8x
- Instruction documents: [instruction documents]
Tools Required
The following tools are needed for installation:
- 4 mm Allen key
- SW 10 wrench
Installation Steps
Step 1: Attaching the Antitipper Tube
Illustration shows a close-up of a wheelchair front wheel assembly. Two mounting pins are being inserted through holes in the chair frame and the antitipper tube. These are then secured with washers and nuts. Arrows indicate the direction of insertion.
Procedure:
- Align the antitipper tube with the designated mounting points on the chair frame near the front wheels.
- Insert the straight metal pins through the aligned holes.
- Place washers and nuts onto the pins to secure the tube.
Step 2: Completing the Installation
Illustration shows another close-up of a wheelchair front wheel assembly, detailing the final attachment of the antitipper bar. Arrows indicate the insertion of pins, secured by washers and nuts. A torque specification is provided.
Procedure:
- Repeat the process from Step 1 for the second antitipper tube on the opposite side of the chair.
- Ensure all pins, washers, and nuts are securely fastened.
- Tighten the fasteners to a torque of 3 - 4 Nm.
