RESISTEX AIKLA Lighting Fixture

Installation Guide

Applique (Wall Mount)

Step 1: Fixture Overview

The luminaire is a rectangular unit with dimensions approximately 164mm in length, 67.5mm in height, and a diameter of 5mm for mounting points. The overall length is 191mm, with a depth or width of 44mm.

Step 2: Mounting Bracket and Wiring

A mounting bracket is secured to the installation surface. Electrical connections are made to a terminal block. The block has terminals labeled N (Neutral), L (Line/Live), and E (Earth). The installation requires using H05RN-F and U-1000 R2V type cables. A green checkmark ✅ indicates correct wiring, while a red cross ❌ indicates incorrect wiring. A warning symbol ⚠ highlights the risk of electrostatic discharge.

Step 3: Attaching the Fixture

The luminaire is attached to the mounting bracket using TORX PLUS screws. An arrow indicates the direction of attachment.

Step 4: Final Installation (ON)

The fixture is shown mounted and powered ON.

Borne (Post/Pole Mount)

Step 1: Base Installation

A base plate, measuring approximately 230mm by 230mm with a central Ø10mm hole, is installed on the ground. The diagram shows it being secured in soil using anchors or stakes, with recommended spacing of 15cm from edges.

Step 2: Mounting Bracket Attachment

A mounting bracket is attached to the base plate.

Step 3: Wiring Connections

Similar to the wall mount, electrical connections are made to a terminal block labeled N, L, and E, using H05RN-F and U-1000 R2V cables. Correct wiring is indicated by a green checkmark ✅, and incorrect by a red cross ❌. A warning symbol ⚠ is present for electrostatic discharge precautions.

Step 4: Final Installation (ON)

The fixture is shown attached to the post/base and powered ON.