nVent VARISTAR CP Screwed Divided Side Panel Installation Guide

Introduction

This document provides comprehensive instructions for the installation of the nVent VARISTAR CP screwed divided side panel. It details the necessary components, assembly steps, and important mounting specifications to ensure correct and secure installation.

The document is presented in English, which serves as the primary language for clarity and accessibility.

Parts Identification

The following components are essential for the assembly process:

• Part 1 (2x): The primary side panel component.
• Part 2 (2x): The secondary side panel component, completing the divided side assembly.
• Part 3 (4x): Snap-in fasteners or clips, designed for secure attachment.
• Part 4 (8x): Mounting brackets or clips, used for frame attachment.
• Part 5 (4x): Screws, typically of an M6 type, for securing panels.
• Part 6 (4x): Washers or gaskets, used in conjunction with screws for sealing or load distribution.
• Part 7 (8x): Screws, typically of an M5 type, for final panel securing.

Mounting Specifications

Tightening Torques: All specified tightening torques are provided with a tolerance of +/- 15%, unless an alternative value is explicitly stated.

• For screws (Part 5): A torque of 3.5 Nm is recommended.
• For screws (Part 7): A torque of 3 Nm is recommended.

Marking and Positioning: The cabinet frame features specific markings to guide the placement of mounting brackets. These are typically referenced against the overall cabinet height:

• For cabinets with a total height of 2450 mm, markings are located 100 mm from a reference point.
• For cabinets with a total height of 2000 mm or 2200 mm, markings are located 75 mm from a reference point.
• An additional measurement of 74.00 mm is indicated for precise bracket placement in certain configurations.

Assembly Steps

Step 1: Attach Snap-in Fasteners

Begin by attaching two snap-in fasteners (Part 3) to the designated slots on the main cabinet frame. These fasteners are designed to engage with a distinct "CLICK" sound, indicating secure locking.

[Diagram Description: Illustrates the insertion of a snap-in fastener (Part 3) into a frame slot, showing the mechanism engaging and locking with an audible "CLICK".]

Step 2: Install Mounting Brackets

Proceed to attach four mounting brackets (Part 4) to the vertical profiles of the cabinet frame. Ensure that the brackets are positioned accurately according to the pre-marked indicators on the frame, taking into account the cabinet's height specifications (e.g., 100 mm or 75 mm offsets).

[Diagram Description: Shows the attachment of mounting brackets (Part 4) to the vertical frame members. Key dimensions for placement are highlighted: 100 mm for H.2450, 75 mm for H.2000/H.2200, and a 74.00 mm measurement for precise alignment.]

Step 3: Install First Side Panel

Carefully slide the first side panel (Part 1) into its designated position within the frame. Secure this panel using two screws (Part 5) in conjunction with two washers/gaskets (Part 6). Tighten these screws to the specified torque of 3.5 Nm.

[Diagram Description: Depicts the process of sliding the first side panel (Part 1) into the cabinet frame. It then shows the panel being fastened with two screws (Part 5) and two washers/gaskets (Part 6), with the torque value of 3.5 Nm indicated.]

Step 4: Install Second Side Panel

Finally, slide the second side panel (Part 2) into place within the frame. Secure this panel using four screws (Part 7). Tighten these screws to the specified torque of 3 Nm.

[Diagram Description: Illustrates the installation of the second side panel (Part 2) into the frame. The panel is then secured with four screws (Part 7), and the torque value of 3 Nm is shown.]