Chapter 1: Item in the Box
You will see the following items when opening the box:
- RP582B 802.11ax router/extender: 1
- Power adaptor (DC IN: 12V/2A): 1
The box contains a tall, slender, dark-colored electronic device identified as the RP582B 802.11ax router/extender, and a power adapter with a cable and plug.
Chapter 2: Prepare to Power On
Follow these steps to prepare the device for power on:
- Connect the WAN cable to the RJ45 port (Internet).
- Connect the LAN cable to the RJ45 port (Ethernet).
- Connect the power adaptor DC plug to the RP582B Power connector, and then connect the power adaptor to an AC Plug.
Device Diagram Description:
- Top: Features a Venting Outlet.
- Left Side: Shows the Left Cover, made of black plastic with MT11020 treatment.
- Middle Section: Shows the Mid Cover, made of black plastic with MT11020 treatment.
- Right Side: Displays the Right Cover (black plastic, MT11020 treatment), Indicators (LEDs), and the I/O Interface (ports).
- Bottom: Features a Venting Inlet.
Chapter 3: LED Behavior When Boot Up
LED Color: Blue
LED State: Solid
The LED will change to a green breathing pattern (indicating it is searching for an internet connection) after the device has booted.
The LED will turn off once the Internet connection is successfully established.
Regulatory Information
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Operations in the 5.15-5.25GHz & 5.85-5.895GHz band are restricted to indoor use only.
Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 24cm between the radiator and your body.
Note: The country code selection is for non-US models only and is not available for all US models. Per FCC regulation, all WiFi products marketed in the US must be fixed to US operation channels only.
Industry Canada Statement
This device complies with ISED's licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d' ISED applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable.
Caution:
- (i) The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems;
- (ii) Where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be clearly indicated.
Avertissement: Le guide d'utilisation des dispositifs pour réseaux locaux doit inclure des instructions précises sur les restrictions susmentionnées, notamment :
- (i) les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une utilisation à l'intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux;
- (ii) lorsqu'il y a lieu, les types d'antennes (s'il y en a plusieurs), les numéros de modèle de l'antenne et les pires angles d'inclinaison nécessaires pour rester conforme à l'exigence de la p.i.r.e. applicable au masque d'élévation, énoncée à la section 6.2.2.3, doivent être clairement indiqués.
Radiation Exposure Statement: This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with greater than 24cm between the radiator & your body.
Déclaration d'exposition aux radiations: Cet équipement est conforme aux limites d'exposition aux rayonnements ISED établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé à plus de 24cm entre le radiateur et votre corps.
