GE Pre-Lit Christmas Tree Assembly Instructions

Introduction

Nicolas Holiday Ltd. thanks you for purchasing this pre-lit Christmas tree. For any issues, visit www.geholidaylighting.com or call toll-free at 1-877-398-7337. The website also provides service hours and assembly instruction videos.

Assembly Instructions

Estimated Assembly Time: 10-15 minutes

Tools Required: None

Tree Assembly Diagram

The diagram shows a 7.5 FT Christmas tree with three main sections: 'TOP', 'B', and 'A' from top to bottom. Section 'A' connects to the 'Tree Stand'. A 'Tree top connector' is also indicated.

Schematic Diagram Summary

1. Unpack and Inspect: Carefully unpack the carton. Remove bubble wrap and inspect all tree sections: "A", "B", "Top", and the "Tree Stand".
2. Set Up Tree Stand: Open the tree stand and set it at a 90° angle.
3. Assemble Section A: Insert Section A into the tree stand and tighten the thumbscrew. Plug the tree into an electrical wall outlet.
4. Shape Branches: Untie the RED twist-tie to release the branch panels. Gently pull the outer layer of branches to allow them to fall into place.
   • Fig. A: Start from the inner branches and stagger the tips. Move each tip up to approximately 40°.
   • Fig. B: Adjust specific tips: tips 2 & 3 to a horizontal position, tip 4 to a vertical position, and tips 5 & 6 to a 45° angle.
5. Assemble Section B: Properly insert section "B" into the top of section "A". Adjust branch tips for a fuller look.

   Electrical Connection (Sections A & B): Fully insert the plug from the extension cord attached to the pole of the middle section into the extension cord outlet attached to the pole near the top of the bottom section.

6. Shape Section B: Repeat Step 4 for shaping the branches of section B.
7. Assemble Tree Top: Properly insert the "TOP" section into the top of section "B". Adjust branch tips for a fuller look.

   Electrical Connection (Top Section): To illuminate the top, fully insert the plug from the top section into either the end connector or the extension cord outlet on or near the top layer of branches of the previously assembled pole.

Troubleshooting Tips

• Tree Not Illuminating: Ensure the wall switch is turned on. If connected to a switched outlet, check that switch.
• One Section Not Illuminating: Check the section for loose or missing bulbs. Verify all factory connections are properly made and that you have correctly connected each tree section. Check the fused plug for a missing or burned-out fuse.

DISCLAIMER: DO NOT USE OR INSTALL ANY ADDITIONAL CHRISTMAS LIGHTING OR ORNAMENTATION THAT IS POWERED BY A LIGHT BULB SOCKET. Doing so may result in damage to your Christmas tree or cause personal injury, and will void the limited warranty of this product.

Disconnect the decorative item from the power source before performing any maintenance or cleaning.

Usage: For indoor use only. Requires 120V. This is not a toy; it is for decorative use only.

GE is a trademark of General Electric Company and is used under license by Nicolas Holiday Ltd.

©2022 Nicolas Holiday Ltd. All rights reserved.

Tree Storage

1. Remove the tree's main extension cord plug from the wall outlet.
2. Starting from the top, disconnect the "TOP" section from section "B", and then disconnect section "B" from section "A". Gently fold the branch tips and branches towards the center, taking care to avoid damaging the lights.
3. Remove section "A" from the tree stand and close the tree stand to place it into the carton.
4. Refer to the drawing on how to repack your tree.

IMPORTANT: Store your carton neatly in a cool, dry location protected from sunlight to prolong the tree's life and maintain the lights' working order. Do not place a heavy load on the carton to avoid damage or crushing.

Spare Parts Included