Drive Medical Pivot & Tilt Overbed Table

Lifetime Limited Warranty

Your Drive brand product is warranted to be free of defects in materials and workmanship for the lifetime of the original consumer purchaser.

This device was built to exacting standards and carefully inspected prior to shipment. This Lifetime Limited Warranty is an expression of our confidence in the materials and workmanship of our products and our assurance to the consumer of years of dependable service.

In the event of a defect covered by this warranty, Drive Medical will, at its option, repair or replace the device.

This warranty does not cover device failure due to owner misuse or negligence, or normal wear and tear. The warranty does not extend to non-durable components, such as rubber accessories, casters, and grips, which are subject to normal wear and need periodic replacement.

If you have a question about your Drive device or this warranty, please contact an authorized Drive dealer.

For more information, visit www.drivemedical.com.

Assembly & Operating Instructions

Note: Spare part 2 is packed separately and included in the box.

Assembly Steps:

• Release knob 1 before straightening tube 2.
• Tighten knob 1.
• Release knob 4.
• Secure tube 5 into part 6 by pushing the button.
• Screw on part 3 for up and down setting.

Key Components & Features:

• Locking Device: Mechanism to secure the table in place.
• Protective Trim: Edge protection for the table surface.
• Height Adjustment Knob: Knob used to adjust the table's height.
• Folding Knob: Knob used for folding or adjusting the table's tilt.
• Casters With Locks: Wheels equipped with locking mechanisms for stability.

Assembly Visual Guide (Textual Description):

Step 1: Diagram shows the initial assembly of the overbed table base and upright tube, indicating connections for parts labeled 1 and 2.

Step 2: Diagram illustrates attaching the table top to the main structure, highlighting the height adjustment mechanism (part 3), release knobs (parts 1 and 4), and securing tube 5 into part 6 via a push button.

Complete: Diagram shows the fully assembled Pivot & Tilt Overbed Table, ready for use.