Dettson Hydra Industrial Electric Boiler

Introduction

This manual provides essential information for the installation, operation, and maintenance of the Dettson Hydra Industrial electric boiler. It is designed for both installers and homeowners to ensure safe and efficient use of the equipment. Please read all instructions carefully before proceeding with installation or operation.

Key Features and Models

The Hydra Industrial series electric boilers are manufactured by Dettson Industries Inc. This document covers various models, including:

• HYDRAI016 series
• HYDRAI024 series
• HYDRAI032 series
• HYDRAI040 series
• HYDRAI048 series
• HYDRAI064 series
• HYDRAI080 series
• HYDRAI096 series

For detailed specifications, refer to the technical specifications section.

Safety Precautions

WARNING: Installation and servicing must be performed by qualified personnel. Always follow local and national codes, including the Canadian Installation Code for Hydronic Heating Systems CSA B214-01 and the Canadian Electrical Code CSA C22.1.

DANGER: Immediate hazards which WILL result in death or serious injury.

WARNING: Hazards or unsafe practices which CAN result in death or injury.

CAUTION: Hazards or unsafe practices which CAN result in personal injury, product or property damage.

Ensure proper clearances are maintained as specified in Table 1. Never tamper with the unit or its controls; contact a qualified service technician.

Installation Overview

The boiler must be installed in a dry, non-corrosive environment with adequate ventilation and an ambient temperature not exceeding 27°C (80°F). Follow the mounting instructions and ensure the unit is level. The distribution system should operate at a maximum pressure of 28 psi, with temperatures ranging from 15°C to 88°C (60°F to 190°F).

Electrical power supply must be a 3-phase, 60 Hz circuit, protected by an appropriately sized breaker. Refer to the boiler nameplate and technical specifications for correct wire and breaker sizing.

Operation and Maintenance

The electronic control allows for adjustments to setpoint temperature, pump operation, and other parameters. Familiarize yourself with the control interface for optimal performance. Regular maintenance, including purging the boiler annually and checking electrical components, is recommended to ensure longevity and efficiency. For detailed maintenance procedures, consult Section 3 of this manual.

Contact Information

For questions regarding operation, maintenance, or warranty, please contact the company where the equipment was purchased. Dettson Industries Inc. can be found at www.dettson.ca.