Omnilux Contour GLOVE

STEP 1

Before using your GLOVE, charge the in-unit battery/controller. The controller must be charged prior to treatment using the cable and in-unit controller provided with the device.

[Diagram: Shows a USB cable connecting the controller to a power source.]

STEP 2

Once fully charged (all 3 charging lights will be illuminated), detach the in-unit controller from the charging cable.

NOTE: Please do not charge the in-unit controller with the GLOVE turned on, as this may cause damage to the battery.

[Diagram: Shows the controller with three illuminated charging lights. A second diagram shows a red 'X' over a cable connected to the glove, indicating it should not be charged while the glove is on.]

STEP 3

To reiterate, the Omnilux Contour GLOVE is operated by the supplied in-unit controller, making it completely portable.

[Diagram: Shows the Omnilux Contour GLOVE on a hand with the controller unit attached.]

STEP 4

The device is designed to sit comfortably on your hand. It should feel secure but not overly tight.

[Diagram: Illustrates the Omnilux Contour GLOVE fitting securely and comfortably on a hand.]

STEP 5

Activate the device by pressing down on the button for one second. Each session is 10 minutes, and your device will automatically shut off when the treatment is complete. Omnilux recommends using the device at least 3-5 times per week for 4-6 weeks, and then continued maintenance thereafter for all natural, radiant-looking skin!

[Diagram: Shows a finger pressing the activation button on the controller unit.]

STEP 6

Store your GLOVE flat if possible. Clean the treatment surface as needed with a damp cloth or a nonirritating water-based wipe. For deeper cleaning, wipe gently with 70% alcohol.

[Diagram: Shows the Omnilux Contour GLOVE lying flat, with a hand cleaning its surface.]

Any questions? Visit omniluxled.com/apps/help-center for more detailed instructions on how to get the most from your Omnilux Contour GLOVE.