LeapFrog Scout's Ring & Record Learning Phone

Introduction

Thank you for purchasing the Scout's Ring & Record Learning Phone™! Dial up some fun as you explore numbers, the Alphabet Song, weather, greetings in Spanish and Mandarin, and more. You can also save a voice message on the device by using the Record Button. Then, play it back by pressing the Message button or activate the Silly Slider to hear your message added to songs or played in funny voices!

Key components of the phone include:

• Play/Demo switch: Located on the back of the toy to select play or demo mode.
• Silly Slider: Allows for silly sounds or transformed voice messages.
• Off/Low/High volume switch: Controls the device's volume and power.
• Number buttons: Each button offers multiple audio options (number names, learning phrases, silly sounds).
• Message button: Plays pre-recorded fun messages from Scout or user-recorded messages.
• Record button: Used to record voice messages.
• Phone/zero button: Initiates calls to Scout and friends, or answers incoming calls.

Included in the Package

• Scout's Ring & Record Learning Phone™
• Quick Start Guide

WARNING: All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords, and packaging screws are not part of this toy and should be discarded for your child's safety.

NOTE: Please save this Instruction Manual as it contains important information.

ATTENTION: For your child's safety, discard all packaging materials such as adhesive tapes, plastic sheets, fasteners, labels, cords, and packaging screws. They are not part of the toy.

NOTE: It is advisable to save this user manual as it contains important information.

Unlock the Packaging Locks:

1. Turn the packaging lock counterclockwise several times.
2. Pull out and discard the packaging lock.

Activate Standard Play Mode

This product is in Demo mode in the packaging. To activate standard Play mode, please complete the following steps:

1. Locate the Play/Demo switch on the back of the toy.
2. Slide the switch from Demo to Play.

The recorded message will now be saved when the toy is powered off.

Getting Started: Battery Removal and Installation

1. Make sure the unit is turned Off.
2. Find the battery cover located on the back of the unit. Use a screwdriver to loosen the screw and then open the battery cover.
3. Remove old batteries by pulling up on one end of each battery.
4. Install 3 new AAA (AM-4/LR03) batteries following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.

WARNING: Adult assembly required for battery installation. Keep batteries out of reach of children.

ATTENTION: Batteries must be installed by an adult. Keep batteries out of reach of children.

Important: Battery Information

• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.

Rechargeable Batteries:

• Remove rechargeable batteries (if removable) from toy before charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.

Product Features

1. Off/Low/High Volume Switch

Slide the selector to Low or High to turn the device on and select the desired volume. To turn the unit off, slide the selector to the Off position.

2. Number Buttons

Each button has three types of audio. Press a button multiple times to cycle through number names, learning phrases, and silly sounds.

3. Message Button

If no user messages have been recorded, press to hear fun messages from Scout. If a user has recorded a message, press this button to hear it.

4. Phone/Zero Button

Press to call Scout and his friends. Sometimes Scout and his friends will even call you! The phone will ring and this button will flash. Press it to answer the call.

5. Record Button

Press to record a message. When you are finished, press again to end the message. The maximum message length is 10 seconds. After a message has been saved, press the Message Button to hear it or move the Silly Slider to the right to listen to it added to a song or played in a funny voice.

6. Silly Slider

Slide to the left to hear silly sounds. If a message has been recorded, slide to the right to hear the message made into a song or listen to it transformed into a funny voice.

7. Play/Demo Switch

When this slider is in Demo, the recorded message will not be saved after the device is powered off. Slide to Play to save a recorded message even when the device is powered off.

Songs

Ring and Record

Ring and record!
I love to sing and record.
Pick up the phone and leave a message at the beep.
Woof woof woof!

Alphabet Song

A-B-C-D-E-F-G,
H-I-J-K-L-M-N-O-P
Q-R-S-T-U-V
W-X-Y and Z!

Rainbow Song

We stick together in sunny weather.
Rain go way, come again some other day.
Ooh, there's a rainbow!
Lovely colors too!
Red, orange, yellow, purple, green and blue!

Can You Find It Song

Can you find it? Can you find it?
Touch your nose (or "belly" or "toes")!

Care & Maintenance

1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat sources.
3. Remove the batteries if the unit will not be in use for an extended period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.

Troubleshooting

If for some reason the unit stops working or malfunctions, please follow these steps:

1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.

IMPORTANT NOTE: If the problem persists, please call our Consumer Services Department at 1-800-701-5327 in the U.S. and Canada, or email support@leapfrog.com. LeapFrog Enterprises, Inc. is responsible for creating and developing LeapFrog products and takes this responsibility seriously. Efforts are made to ensure the accuracy of information, which forms the value of our products. However, errors can occur. It is important to know that LeapFrog stands behind its products and encourages users to contact them with any problems and/or suggestions. A service representative will be happy to help.

Environmental Phenomena & FCC Compliance

The unit may malfunction if subjected to radio-frequency interference. It should revert to normal operation when the interference stops. If not, it may become necessary to turn the power off and back on, or remove and reinstall the batteries. In the unlikely event of an electrostatic discharge, the unit may malfunction and lose memory, requiring the user to reset the device by removing and reinstalling the batteries.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Supplier's Declaration of Conformity

47 CFR § 2.1077 Compliance Information

Trade Name: LeapFrog®

Model: 6209

Product Name: Scout's Ring & Record Learning Phone™

Responsible Party: LeapFrog Enterprises, Inc.

Address: 2200 Powell St., Suite 500, Emeryville, CA 94608

Website: leapfrog.com

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

Resources

Visit our website for more information about our products, downloads, resources, and more.

leapfrog.com

leapfrog.ca

Read our complete warranty policy online at:

leapfrog.com/warranty

leapfrog.ca/warranty

LeapFrog Enterprises, Inc.
A subsidiary of VTech Holdings Limited.
TM & © 2024 LeapFrog Enterprises, Inc.
All rights reserved.
IM-620900-000
Version:0