USER MANUAL
LP1035V2 High-Output Focusing Handheld Flashlight
Model: LP1035V2
Operation Instructions
On/Off: Press and release the button on the tail cap to turn the light on and off.
Cycle Modes: Press button on tail cap quickly to cycle through modes (High/Medium/Ultra-Low). If light remains in a single mode for longer than 3 seconds, the next press of the button will turn the light off. Light automatically rests to High mode when turned off.
Hidden Strobe On/Off: Press and hold button for 3 seconds to activate hidden strobe. Flashlight will remain in hidden strobe mode until it is deactivated by pushing and holding the button for 3 seconds again.
Focus Head: To focus the light beam, gently push the head away from the light to extend it. Pull the head back towards the light to widen the beam.
[Illustration of the flashlight's tail cap with the power button.]
[Diagram showing how to adjust the focus beam by pushing or pulling the flashlight head.]
Features
- Constructed with aircraft-grade aluminum
- LPE optics
- Push/pull focus beam
- Patented TackGrip molded rubber grip
- High quality wrist lanyard
- Tactical on/off button
- IPX4 waterproof rating
- Batteries included (4 AAA)
[Image of the Lux Pro LP1035V2 flashlight.]
ANSI/PLATO FL1 Standard Specifications
| MODES | LUMENS | RUN TIME | BEAM DISTANCE |
|---|---|---|---|
| High | 570 lm | 2h | 275m |
| Medium | 175 lm | 6h | 165m |
| Low | 43 lm | 22h | 80m |
| Strobe | 470 lm | -- | -- |
Battery Replacement
The LP1035V2 uses 4 AAA batteries.
To replace the batteries, turn the tail cap counterclockwise to remove it. Tip the light downward to slide out the battery case which contains the batteries. Remove the batteries from the case and insert new batteries according to the (+/-) symbols found on the case. For best results, use brand new alkaline batteries that are the same voltage and brand.
Re-insert the battery case into the flashlight with the arrow on the battery case pointing down. Re-attach the tail cap by pressing down lightly and turning it clockwise until tight.
If you know it will be a while between uses, we suggest removing the batteries from the flashlight and storing it in a dry, protected place.
[Illustration showing the flashlight disassembled, with the battery case and AAA batteries separated.]
Product Warranty
The LP1035V2 has a Limited Lifetime Warranty Against Manufacturer's Defects from time of purchase.
For warranty claims please contact Lux Pro by calling 801-553-8886 or sending an email to info@simpleproducts.com.
Visit luxpro.com for more information.
Lux Pro
14725 S Porter Rockwell Blvd Ste C
Bluffdale, UT 84065
866.553.8886
