Sharp Projector Quick Setup Guide

Getting Started

1. Connect your computer to the projector using the HDMI cable. (Cable not supplied)
2. Connect the supplied power cord. Ensure the prongs are fully inserted into both the AC IN terminal and the wall outlet.
3. Remove the lens cap.
4. Turn on the projector.

Selecting a Source

1. Press the INPUT button on the projector cabinet or the HDMI1 or HDMI2 button on the remote control.

Adjusting Image Size and Position

CAUTION: Perform adjustments from behind or the side of the projector. Adjusting from the front may expose your eyes to strong light and cause injury.

• [LENS SHIFT]
  On the projector, press the LENS SHIFT ▲ or ▼ button.
  On the remote control, press the SHIFT button, then press the ▲ or ▼ button.
• [FOCUS]
  On the projector, press the FOCUS + or - button.
  On the remote control, press the FOCUS or ZOOM button, then press the ◄ or ► button.
  You can manually adjust the peripheral focus in addition to the powered focus. Turn the peripheral focus ring clockwise or counterclockwise.
• [ZOOM]
  On the projector, press the ZOOM + or - button.
  On the remote control, press the FOCUS or ZOOM button, then press the ▲ or ▼ button.

Turning Off the Projector

1. Press the ⚡ (POWER) button on the projector cabinet or the STANDBY ⏻ button on the remote control.
2. Press either the ⚡ (POWER) or the STANDBY ⏻ button again.
3. Mount the lens cap.
4. Disconnect all cables.