Plumber's Putty Instruction Guide

Instructions

1. Open the lid on the container and remove the desired amount of putty for your application.
2. Ensure the lid is securely placed back on the container to prevent debris from entering and mixing with the clean putty.
3. Knead the putty in your hands until it becomes soft and pliable. Form it into a rope approximately 1/2 inch thick.
4. Place the putty rope around the underside of the product's flange that you are installing. Blend the two ends of the rope together where they meet.
5. Install your product (e.g., bath waste, shower drain, pop-up or basket strainer). As you secure the product, excess putty will ooze out from under the flange.
6. After the product is properly secured, remove the excess putty and wipe the area clean.
7. If using the putty in colder applications, wait 10 minutes after the initial installation. Confirm that the product does not require an additional turn to secure it properly.
8. Any excess putty that is still clean and free of debris can be blended back into the container.

Important Information

© 2020 Oatey SCS. All Rights Reserved.

This information is based on data believed to be reliable, but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out of its use. The data listed falls within the normal range of product properties but should not be used to establish specification limits or used alone as the basis of design. Oatey's liability to purchasers is expressly limited to the terms and conditions of sale.

Oatey is a trademark of Oatey Co. All other trademarks can be found at www.Oatey.com.