This document serves as a user manual for a high-quality parking sensor system, designed as an auxiliary warning device for vehicles. It provides essential information for installation and operation.
Installation Guide
Host and Monitor Installation: The monitor should be placed in the upper left corner of the vehicle's cabin for optimal driver visibility. Secure the host unit on either side of the car's back box, avoiding areas prone to heat, humidity, or water leakage.
Sensor Installation: Sensors are typically mounted on the rear bumper. Ensure proper height (0.5-0.8m) and placement for accurate detection. The surface where sensors are mounted should be flat.
Important Notes
- The system's performance may be affected by slick slopes or uneven surfaces.
- Keep sensor surfaces clean for optimal functionality.
- Avoid damaging the sensor wires during installation or use.
- Ensure the vehicle speed is low when reversing for accurate sensor readings.
Technical Parameters
Parking Sensor Parameters
| Parameter | Value |
|---|---|
| Voltage | 9--15 DCV |
| Rated Voltage | 12DCV |
| Power Cost | <0.5w |
| Respond Cost | 0.3--2.0m |
| Sensor Diameter | 22mm |
| Sensor Angle | x y 60° |
| Alarm Volume | 65DB |
| Work Temperature | -30°C -- +80°C |
| Power (Wireless) | 10mw |
| FM (Wireless) | 433MH/2.4GHZ |
TFT Monitor Parameters
| Parameter | Value |
|---|---|
| Work Voltage | 9--15 DCV |
| Rated Voltage | 12DCV |
| Power Cost | <3w |
| Display Resolution | 320RGB*240 /480RGB*234 |
| Display Rated | 4:3 /16:9 |
| Video Input | 2 way |
| Work Temperature | -30°C -- +80°C |
Wiring Diagram
The system connects the monitor to the cigarette lighter for power. The sensors are mounted in the rear bumper and connect to the reversing lamp and ground (GND).
