Assembly Instruction
speakON® | Loudspeaker Cable Connector
NL2FXX-W-* & NL4FXX-W-*
Important Safety Information
⚠️ ATTENTION: speakON® is not to be used as an AC mains or power supply connector!
❗ CAUTION: Connector not to be engaged and disengaged in normal used when live or under load.
⚠️ ATTENTION: NE PAS UTILISER POUR COUPER LE COURANT
PRODUCT IS INTENDED FOR FACTORY ASSEMBLY ONLY
Approval Based
| EN/IEC | UL/CSA | |
|---|---|---|
| Approval | EN 61984 IEC 61984 | UL 1977 CAN/CSA C22.2 No.182.3 |
| Rating | 250 V ac / 30 A | 250 V ac / 30 A |
| Wire size | 1.0 - 4.0 mm² | 16 - 11 AWG |
| Cable O.D. | 6.0 - 12.0 mm (0.24 - 0.47") | 6.0 - 12.0 mm (0.24 - 0.47") |
| *-S: | 10.0 - 16.0 mm (0.39 - 0.63") | 10.0 - 16.0 mm (0.39 - 0.63") |
| *-L: |
Assembly Information
Step A: Cable Preparation
Place the bushing (1) and chuck (2) over the cable. Important: Chuck and Bushing cannot be placed over the cable after the assembly or the insert.
Step B: Cable Preparation
Prepare the cable as shown. For 2-pole connectors, strip 27 mm [1.06"] of the outer jacket and 9 mm [0.35"] of the inner conductors. For 4-pole connectors, strip 27 mm [1.06"] of the outer jacket and 9 mm [0.35"] of the inner conductors.
Step C: Wiring and Clamping
Slide the cable into the contacts and clamp. For 2-pole wiring, connect to terminals 1+ and 1-. For 4-pole wiring, connect to terminals 1+, 1-, 2+, and 2-.
Torque Value: 0.7 Nm (6.2 inch-pounds) using a T8 Torx size bit.
Step D: Chuck and Insert Assembly
Position chuck (1) on insert (2).
Step E: Housing Assembly
Slide insert (2) with chuck (1) together into housing (3). Important: Align the chuck by positioning the nose into the keyway. Slide bushing (4) over chuck (1).
Step F: Final Tightening
Hold the connector with the Neutrik tool (5) HTLACA and tighten the bushing with the Neutrik tool (6) HTLACB. For an exact mounting position, use a torque wrench with a 27 mm (1 1/8 inch) hex bit (7) and tighten it to 2.5 Nm (22 inch-pounds / 1.8 lb-ft).
Finished Connector
The finished connectors are the NL2FXX-W-* and NL4FXX-W-* models.
Disassembly Information
For Disassembly:
- Use the Neutrik tool HTLACB.
- Position the tool on the surfaces and open the clamping sleeve.
Safety Information
❗ CAUTION: To ensure protection category, do not expose the connection to bending forces (e.g., do not attach loads to the cable, no free-dangling cable windings etc.).
⚠️ SAFETY WARNING: For safety and certification reasons, the connector must be replaced in case of any broken parts or excessive wear and tear.
More Information
For more information, visit www.neutrik.com/products/audio/speakon.
Homepage - Neutrik
