Quick Reference Guide

To Run Fan Only

Press Mode to select Fan Only. Fan will circulate air inside the room without air conditioned cooling.

To Compensate for Opening Doors

Press Fan Speed button to increase fan speed. You may also select Auto Fan, which will speed up or slow down fan speeds automatically based on significant changes in room temperature.

To Go to Sleep

Press the Sleep button. Temperature increases 4°F or 2°C over 1 hour and then holds this elevated setting for 7 hours.

To Enter Timer On or Timer Off

To delay stop(or start), press the Timer button when the unit is power-on(or power-off), then the "timer off" indicator(or "timer on" indicator) will illuminate. Set the delay stop(or start) timer, then the control will count down the time(8, 7.5, 7, etc.) left, and all other settings will remain the same as they were before the timer setting is confirmed, until stop(or start).

Setting combination of “delay stop turn off, delay start” or “delay start turn on/ delay stop" is workable. The timer setting can be canceled by either pressing and holding the timer button for 2 seconds, or pressing the power on/off button at any time to turn off the unit directly.

To Clean the Air Filter

After 250 hours of use the Filter light will illuminate to remind you to clean air filter. Press Filter button to turn off light.

To Change Temperature unit

Press and hold the up and down buttons together for 3 seconds to change the display temperature unit between °F and °C.