Nakamichi NC-A210 User Manual

Specifications

Installation

Please read these instructions carefully before installation and use. Installation should be performed by professional staff.

A. Installation Instruction for Embedded/Punching Camera

1. Before making a hole in the car, please ensure the diameter of the camera equals the drill bit.
2. According to the arrow indicated direction (up) to install.
3. Insert the lead wire of the camera into the hole and then begin to install the camera.
4. Using two thumbs to push the camera into the car with balanced forces.

B. Installation Instruction for Hanging Camera

1. For easy installation, use a drill to open a screw hole at the appropriate position in the rear license plate of the car.
2. Tighten the first screw into the screw hole with a screwdriver.
3. Adjust the camera's position according to the actual display on the monitor.
4. After adjustment, use a drill to open the second screw hole.
5. After fixing the second screw, all installation steps are finished.

C. Installation Instruction for License Plate

1. Take out the license plate, adjust the direction up and down.
2. Align the license plate to the installation location of the car.
3. Tighten the screws and install the license plate frame camera.
4. Adjust the up and down angles of the camera, then fix the screw.

D. Assembly Diagram for Exchanging the Front Housing of Punching/Embedded and Hanging Camera

1. As shown in the diagram, change the front housing of the embedded/punching camera to a hanging one.

2. As shown in the diagram, change the front housing of the hanging camera to an embedded/punching one.

Image Instruction

The diagram shows a car's rear view with the camera displaying the image on a car DVD/Monitor. The camera is connected to the reversing light and ground (GND).

What's in the Box

• Camera x1pc
• 6m Video Cable x1pc
• Ø7×10 mm Screw x3pcs
• User Manual x1pc
• 3M Adhesive x1pc