ASSEMBLY INSTRUCTION

Important note:

1. Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid scratching the parts.
2. Kindly follow the assembly instructions step by step.
3. Do not tighten all screws and bolts until the table is fully assembled.
4. Unscrew the protective plastique supports from the metal insert of the table legs before assembly.

PARTS IDENTIFICATION

• A Table Top

  1pc

• B Mounting Plate

  1pc

• C Pedestal

  4pcs

• D Table Base

  1pc

• E Table Base

  1pc

• F stretcher

  2pcs

HARDWARE IDENTIFICATION

• 1 Long Bolt

  Ø5/16"x75mm

  5pcs

• 2 Bolt

  Ø5/16"x50mm

  8pcs

• 3 Spring Washer

  Ø5/16"x11mm

  13pcs

• 4 Flat Washer

  Ø5/16"x19mm

  13pcs

• 5 Allen Key

  M4

  1pc

STEP 1

Attach the stretcher (F) to the pedestal (C) parts. The diagram shows two stretcher parts (F) being inserted into slots on two pedestal parts (C). Arrows indicate the direction of insertion.

STEP 2

Connect the assembled pedestal (C) components to the table base (D). The diagram shows two pedestal (C) parts being attached to the table base (D) using bolts. Arrows indicate the connection points. A circular arrow indicates a tightening motion.

STEP 3

Attach the mounting plate (B) to the top of the assembled pedestal structure. The diagram shows the mounting plate (B) being positioned on top of the pedestal assembly. Hardware items 2, 3, 4, and 5 are shown being used for this connection, with the Allen key (5) used to tighten the bolts (2) with washers (3 and 4).

STEP 4

Attach the table base (E) to the underside of the table top (A). The diagram shows the table base (E) being aligned with pre-drilled holes on the underside of the table top (A). Hardware items 1, 3, and 4 are shown being used for this connection, with the Allen key (5) used to tighten the long bolts (1) with washers (3 and 4). A curved arrow indicates a tightening motion.

STEP 5

Connect the assembled base structure to the table top (A). The diagram shows the entire base assembly being attached to the underside of the table top (A). Hardware items 2, 3, and 4 are shown being used for this connection, with the Allen key (5) used to tighten the bolts (2) with washers (3 and 4).

STEP 6

Insert the extension leaf into the table. The diagram shows the extension leaf being slid into the grooves on the main table top. Arrows indicate the direction of insertion. A callout box explains that the slide rail can be moved if holes are not aligned, and advises to move the slide rail to the position shown in the figure and then assemble.

COMPLETE

The table is now fully assembled. The diagram shows the completed table with the extension leaf inserted. It also indicates to attach the Adjust Levelers (4pcs) to the bottom of the table legs.