Assembly Instructions
ITEM: WF291263
Important note:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid scratching the parts.
- Kindly follow the assembly instructions step by step.
- Do not tighten all screws and bolts until the table is fully assembled.
- Unscrew the protective plastique supports from the metal insert of the table legs before assembly.
PARTS IDENTIFICATION
- A Table Top (1pc)
- B Leg (4pcs)
- C Connection panel (2pcs)
- D Long left Stretcher (1pc)
- E Long right Stretcher (1pc)
- F Short left Stretcher (1pc)
- G Short right Stretcher (1pc)
HARDWARE IDENTIFICATION
- 1 Bolt 1/4"X38mm (12pcs)
- 2 Spring Washer 1/4"X11mm (12pcs)
- 3 Flat Washer 1/4"X19mm (12pcs)
- 4 Allen Key (1pc)
- 5 Wood screw #8X50mm (8pcs)
- 6 Wood screw #8X38mm (2pcs)
STEP 1
Attach legs (B) to the connection panels (C) and stretchers (D, E, F, G) using bolts (5) and (6) with the Allen Key (4). Ensure protective plastic supports are removed from leg inserts before assembly.
STEP 2
Insert bolts (1), spring washers (2), and flat washers (3) through the connection panels (C) and into the table legs (B). Tighten using the Allen Key (4).
STEP 3
Attach the table top (A) to the assembled base. Ensure all screws and bolts are securely tightened. A note regarding slide rails: if holes are not aligned during assembly, try moving the slide rail to the position shown in the figure before proceeding.
ITEM: WF291264
Important note:
- Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid scratching the parts.
- Kindly follow the assembly instructions step by step.
- Do not tighten all screws and bolts until the table is fully assembled.
- Unscrew the protective plastique supports from the metal insert of the table legs before assembly.
PARTS IDENTIFICATION
- A Chair Back (1pc)
- B Seat cushion (1pc)
- C Front Leg (2pcs)
HARDWARE IDENTIFICATION
- 1 Long Bolt 1/4"X80mm (4pcs)
- 2 Bolt 1/4"X60mm (4pcs)
- 3 Bolt 1/4"X40mm (2pcs)
- 4 Spring Washer 1/4"X11mm (10 pcs)
- 5 Flat Washer 1/4"X19mm (10 pcs)
- 6 Allen Key (1pc)
STEP 1
Attach the chair back (A) to the seat cushion (B) and front legs (C). Use the provided bolts (1, 2, 3), spring washers (4), and flat washers (5). Tighten using the Allen Key (6). Ensure protective plastic supports are removed from leg inserts before assembly.
STEP 2
Complete the assembly by attaching any remaining parts and ensuring all bolts and screws are securely tightened. The image shows the final assembled chair.
