ALL LED Smart-E AiQ/RLY400B/LN Installation Guide

Returns & Faulty Items

• If any problem is encountered during or after installation, please contact the ALL LED technical department for resolution.
• Do not return items to the point of purchase without prior testing and confirmation of a manufacturing defect/fault. Your statutory rights are not affected.
• The manufacturer is not liable for damages caused by misuse, incorrect installation, or inherent faults/defects. Refer to the troubleshooting guide for assistance.
• All goods are supplied under the terms and conditions of ALL LED LTD. A copy is available upon written request.

General Information

• Interference may occur with other products operating on the 2.4Ghz frequency.
• Product appearance may differ slightly from the image on the box.
• Signal range can be reduced when used within materials like concrete or metal.

Environmental Protection

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice.

The manufacturer will not be deemed liable or held responsible for any damages caused by faults or manufacturing defects that may be present in any of its products or the misuse or incorrect installation of this device. Your statutory rights are not affected.

! PLEASE READ BEFORE USE!

ALL LED LTD
42 Sedgwick Road, Luton, LU4 9DT
www.allledgroup.com
sales@allledgroup.com
Tel: +44 (0)208 841 9000

CE

Technical Specifications

Pairing Instructions

Initial system programming can be done by turning Fusebox Lighting Breakers OFF (5 Seconds), then ON. Then say "Alexa, add a device" or search in the relevant app.

After successful device addition to a network, a 3-minute window opens for finding and binding remotes.

• Network Mode: 60 Seconds
• Find and Bind (for remotes): 3 Minutes

If the 1-minute window expires, switch the module off and on again to re-enter network pairing mode.

Network Pairing Mode:

This mode activates automatically upon the product's first power-on. It allows the smart module to connect to a network hub/gateway and lasts for 1 minute or until a connection is established (indicated by flashing lights). If the time limit is reached, the module returns to normal state with a 3-minute window for remote pairing. To change networks, the module must be factory reset.

Find and Bind Pairing Mode (Remote Control):

Note: When using with a smart device, pair the module and remote to the hub BEFORE pairing with any remote control. For direct module-to-remote pairing, follow the steps below.

To enter this mode, toggle the switch rapidly 4 times (ON > OFF > ON > OFF > ON) or press the module's program button 4 times. This mode allows connecting or disconnecting remote devices (like handheld remotes) and lasts up to 3 minutes or until a connection is established (indicated by flashing lights).

Factory Reset:

To enter this mode, toggle the switch rapidly 7 times (ON > OFF > ON > OFF > ON > OFF > ON) or press the module's program button 7 times. Factory reset removes all paired connections. Successful reset is indicated by flashing lights. After reset, the module automatically enters network pairing mode.

Dimensions

The module measures 52mm in width, 27mm in depth, and 130mm in height. A circular cutout with a diameter of Ø55mm is also indicated.

Wiring Diagram

The wiring diagram shows connections for a light source. It details inputs for 'Live In', 'Neutral', and 'Feed', and outputs for 'Live Out' and 'Switched Live' to the light source.