Delta Single Bike Ceiling Hoist With Straps

Parts

• A: Single Pulley (Back)
• B: Double Pulley (Front)
• C: Screws (x7)
• D: Pulley Hooks (x2)
• E: Cord Cleat (x1)
• F: Cord (x1)
• G: Strap (x2)

Tools Required

• ? Phillips Head Screwdriver
• ⚙️ Drill
• ?️ 1/8" drill bit (3mm)
• ? Tape Measure
• ? Stud Locator

Important Note

It is recommended this item be installed by a competent professional.

Warning

NEVER EXCEED MAXIMUM TOTAL WEIGHT LIMIT OF 100 LBS (46 Kgs). MAX CEILING HEIGHT: 12 FEET. BEFORE USE THOROUGHLY TEST THE HOIST FULLY WEIGHTED WITH THE ITEM INTENDED TO BE STORED, ENSURING THE UNIT HAS BEEN INSTALLED SECURELY AND IS FUNCTIONING PROPERLY.

MAKE SURE THAT THERE ARE NO OBSTRUCTIONS TO RESTRICT OPERATION OF THE HOIST ASSEMBLY AS WELL AS THE HOISTED ITEM; FOR EXAMPLE: VEHICLES, GARAGE DOORS AND OTHER EQUIPMENT.

DO NOT CUT THE CORD.

IMPROPER INSTALLATION OR USE CAN RESULT IN PERSONAL INJURY AND/OR DAMAGE TO PROPERTY.

Assembly Instructions

1. Step 1: Determine Spacing

   Determine the correct distance required between the two pulley hooks. For example, measure from the handlebars to the back of the seat on a bicycle.

2. Step 2: Locate Ceiling Joist

   Locate the ceiling joist. Transfer the distance measurement from Step 1 so that the pulleys will line up correctly along the joist. Alternatively, pulleys can be mounted first onto a board, which can then be securely mounted to joists.

3. Step 3: Prepare the Cord

   Securely tie a double knot ? in the end of the cord. Feed the remaining cord through the hole on the end of the pulley unit that does not have the cord locking mechanism. The knotted end will then be positioned between the ceiling and the pulley bracket.

4. Step 4: Mount Pulleys

   Using the provided screws, carefully mount each pulley into the ceiling joist at the correct distance, ensuring the hooks will line up as measured in Step 1. It is important that the two screws on each pulley are securely mounted into the joist. Pre-drilling 1/8" (3mm) pilot holes will make this job easier.

5. Step 5: Thread the Cord

   Thread the cord through the pulleys as shown in the diagram. Carefully thread the cord down through both parts of the locking mechanism.

6. Step 6: Mount Cord Cleat

   Mount the cord cleat at a safe height, out of reach of small children. Screw it directly into a wall stud using two wood screws. When the item is raised to the desired height, the excess rope should be stored around the cleat. Do not cut the excess cord.

Usage Instructions

Raising an Item

Ensure the hooks ? are properly secured on the item and the cord ? is not twisted before pulling on the cord. The auto-locking device will hold the item suspended with each pull. Once hoisted to the correct height, wrap the excess cord securely around the cleat.

Lowering an Item

Keeping tension in the direction of lowering, slowly let the cord out as the item lowers. Once low enough, remove the item from the hooks and wrap the cord back on the cleat.

Using Straps

First, ensure the bulky item is properly secured, tightening the straps ? as needed at the buckle. Secure the loops onto all of the hooks ? before hoisting the item.

Contact Information

Delta Cycle Corporation
36 York Avenue, Randolph, MA 02368 USA
Phone: 800-474-6615
Website: www.designbydelta.com

For immediate response, please email: service@designbydelta.com