Delta 4 Tier Home Gym Storage Rack

Parts

• A x4 - Uprights with Arms
• B x12 - Screws
• C x12 - Drywall Anchors

Tools Required

• Hand Drill (10/32" or 8mm for drywall)
• Spirit Level
• Tape Measure
• Method for locating studs within the wall (consult hardware store for advice)

Assembly Steps

Step 1: Mounting Uprights

Place the uprights against a located stud on the wall and mark the hole locations. Ensure the top and bottom uprights are vertically aligned (as shown in Figure 1). Then, ensure the second set of uprights are horizontally aligned. Secure the uprights to the wall using the provided screws.

Note: If a wall stud cannot be located, use the included drywall anchors. Drywall anchors require 8mm pilot holes. After drilling the holes, gently tap the drywall anchors into place, then secure the uprights using the screws provided.

Important Safety Note: ⚠️ Beware of drilling into electrical wire or pipes within the wall!

Figure 1 Description: This diagram illustrates the process of mounting the uprights to a wall stud. It depicts the wallboard and stud, with the uprights positioned and marked for drilling. Arrows indicate the required vertical alignment for the main uprights and horizontal alignment for the second set.

Step 2: Adjusting Arms

Swing out the arms to your desired position (as shown in Figure 2). The arms can be rotated to provide extra length, enhancing additional storage capacity.

Figure 2 Description: This diagram shows an arm on the storage rack being swung outwards. A curved arrow indicates the rotation of the arm, signifying its adjustability for increased storage space.

Important Information

Warning

⚠️ Do not allow children to play or hang from the Rack. The maximum weight capacity for a properly installed rack is 60 lbs (27.2 kg) total, with a maximum of 15 lbs (6.8 kg) per tier.