Parts List
- A x1 - Y piece
- B x2 - Straight poles
- C x1 - Bent pole
- D x2 - Legs
- E x4 - Arms
- F x5 - Bolts
Tool Required
Phillips Head Screwdriver [ screwdriver icon ]
WARNING
DO NOT EXCEED MAXIMUM TOTAL WEIGHT LIMIT OF 66 LBS (30 Kgs). MAX LOAD PER HOOK: 25 LBS (7.7 kgs) / MAX WEIGHT PER BIKE: 33LBS (15 kgs)
Assembly Steps
-
Step 1: Initial Assembly
Do not tighten bolts until the rack is fully assembled and tubes are properly aligned. [Diagram shows parts A, B, C, D being loosely connected.]
-
Step 2: Connect Poles and Legs
Connect the straight poles (B) and bent pole (C) to the Y piece (A) and legs (D) using bolts (F). [Diagram shows the main structure being assembled.]
-
Step 3: Attach Arms
Attach the arms (E) to the main pole. [Diagram shows arms E being attached.]
-
Step 4: Tighten Bolts
Tighten all bolts (F) securely before using the stand. [Diagram shows tightening bolts.]
-
Step 5: Adjust Arms and Final Check
Adjust the position of the arms (E) before placing bikes on the stand. [Diagram shows a close-up of arm adjustment and the final stand configuration.]
IMPORTANT / SAFETY
⚠️ In order to avoid accidental toppling of the rack, a wall stabilizing strap is supplied. This should be attached to the rack at one end with the bolt provided. The other end of the strap should be secured to the wall using a screw that is suitable for the type of wall construction. If in doubt, consult your hardware merchant for the correct method of fixing based on the wall construction.
Support and Resources
Need help? Email us at service@designbydelta.com & we'll help solve your issue.
Assembly video: Visit designbydelta.com/downloads
