XTM 4x4 ACCESSORIES
+ AWNING BRACKETS QUICK RELEASE
Instruction Manual
To ensure correct operation, please carefully read the manual before installation.
+ PARTS LIST
- Bracket A: 2 PCS
- Bracket B: 2 PCS
- M8*30mm T Slot bolts: 4 PCS
- M8 Nyloc Nuts: 4 PCS
- M8 Washers: 4 PCS
- M6*20mm Bolts: 8 PCS
- M6 Nyloc Nuts: 8 PCS
+ BRACKETS ASSEMBLY
STEP 1
Using the M8 x 30mm T Slot bolts, washers and Nyloc nuts to assemble the Brackets A on the appropriate position of roof tray.
Diagram Description: Shows Bracket A being attached to a roof tray using M8 x 30mm T Slot bolts, M8 washers, and M8 Nyloc nuts. The components are labeled: Bracket B, M8 x 30mm T Slot Bolt, Roof tray, M8 Nyloc nut, M8 Washer, Brackets A.
STEP 2
Attach the Brackets B to the awning board of the awning with the M6 x 20mm bolts and Nyloc nuts.
Diagram Description: Shows Bracket B being attached to an awning back board using M6 x 20mm bolts and M6 Nyloc nuts. The components are labeled: M6 Nyloc nut, Awning back board, M6 x 20mm Bolt, Brackets B.
+ RELEASE AWNING INSTRUCTIONS
- Pull out index plunger and rotate 90 degrees.
- Lift the slot wheel mounting up then take it out from the Bracket A.
Diagram Description: Illustrates the release mechanism. An index plunger is shown being pulled out and rotated. A slot wheel mounting is shown being lifted and removed from Bracket A.
Remark: To attach awning, just simply reverse the above steps.
+ WARNING
Please read and understand all the following safety information prior to installing and using the awning brackets.
- The awning brackets are designed to fit XTM pullout awnings.
- Ensure that all the mounting brackets are installed correctly as per instructions.
- Inspect the connections periodically to ensure all bolts and nuts are tight.
